AGL 50-OMKAR Controller Parameters - Rev 0
AGL 50-OMKAR Controller Parameters - Rev 0
AGL 50-OMKAR Controller Parameters - Rev 0
Control Wires
Terminal
Wire Ferrule Description
Number
12 BB Safety Input
14 UP UP Command
16 DOWN DOWN Command
18 S1 Slow Speed
20 S2 High Speed
22 DARD
24
Loop
26
28 COM Drive Common
11
Direction Change Over Output in ARD Mode (Transistor O/P)
13
21 M12 / GND
Brake Release Output (Relay)
23 DBK
25 M12 / GND
Drive Run Output (Relay)
27 RKM
JJ Kings Automation
Authorised GEFRAN Drive Distributor
GEFRAN AGL50 Drive Parameters for OMKAR Controller Contact: 9381053454
Rev-0 dated 11-11-2014 PAGE 1 of 2 E-mail: jjkings.automation@yahoo.com
GEFRAN AGL 50 Parameters for OMKAR Controller
Sl.No. PARAMETERS Default Value Set Value PARAMETER DESCRIPTION
Parameter Access
P.998 2 3 Parameter protection code
P.999 0 3 All parameter access level
P.281 75 100 / 68 Ohmic Value Of Braking Resistor
P.282 0.03 0.75 / 1.00 Braking Resistor Power in kW
P.341 0.0 8.0 Max Powerloss Time
P.580 8 1 Output Frequency Display at start up
Setting Parameters
S.180 0.50 0.65 - 1.00 Enter Car Travel Speed(m/Sec)
S.200 10.0 Hz 0.0 Hz Multi Speed-0
S.201 50.0 Hz 7.0 Hz Multi Speed-1 (Slow Speed)
S.202 0.0 Hz 40.0 Hz Multi Speed-2 (High Speed)
S.203 0.0 Hz 15.0 Hz Multi Speed-3 (Inspection Speed)
S.204 0.0 Hz 0.0 Hz Multi Speed-4
S.225 1.00 0.80 Acc/Dec factor
S.230 0.50 0.30 Accc initial jerk
S.231 0.60 0.60 Acceleration
S.234 0.60 0.60 Deceleration
S.251 1.00 0.70 Magnetic time
S.254 1.00 1.00 Dc Brake stop time
S.260 1 0 Lift stop mode
S.301 0 1 Auto boost
Saving Parameters
Press enter key , then display show 'off' then
C.000 off save parameter press up key display show 'do' then again press
enter key then display show 'done' ,save is done
Display Parameters
d.000 Motor Frequency
d.002 Motor Current
JJ Kings Automation
Authorised GEFRAN Drive Distributor
GEFRAN AGL50 Drive Parameters for OMKAR Controller Contact: 9381053454
Rev-0 dated 11-11-2014 PAGE 2 of 2 E-mail: jjkings.automation@yahoo.com