Software For Transformer Test
Software For Transformer Test
Software For Transformer Test
62-1/1
General For testing transformers with lightning and switching impulse an impulse generator, divider and measuring equipment are necessary. For comfortable measurements a digital recorder MIAS will be used. The MIAS is controlled by the impulse analyzer software IAS (Basic Software). The transformer test application is especially performed for testing transformers. Software Requirements The IAS-TRA is an additional software package of the Basic Software IAS (see Data Sheet 5.61), that means, the Basic Software IAS is necessary to use IAS-TRA. This application is prepared for transformer type and routine tests. Special dialogs and menus allow an easy using. Parameter setting The user philosophy is to put in only the necessary test parameters. Whereas the left side of the display shows the recorded wave shapes, the right side is provided to set the measuring parameters such as peak voltage, polarity, time deflection, undershoot in one setup dialog. The software controls the related internal functions.
voltage LI 1.2/50 s
current
HIGHVOLT Prftechnik Dresden GmbH - 0808 - 5-62-1-1.doc - Subject to change without prior notice
Quick start and parameter display In case identical test routines are applied, short cuts and quick start functions on the upper side of the display allow a very fast impulse measuring routine. Evaluated parameters are shown on the right side of the display. Analyzing features Additionally to the standard evaluation methods the following functions are available: Compare / Normalize Function TF Transfer Function Optional evaluations see Data Sheets 5.62-2 and following.
Compare, normalize and transfer function (transformer analysis dialog) These functions will be used to analyze the transformer. The big advantage of one dialog is the easy using. The reference and the test impulse will be easily selected. After that, the analyzing type and the result channels can be selected. With the evaluation button or the start button the function starts to work. The curves will be automatically loaded, evaluated and displayed. No other settings are necessary. Additionally, it is possible to use the transformer analysis quick start button.
HIGHVOLT Prftechnik Dresden GmbH - 0808 - 5-62-1-1.doc - Subject to change without prior notice
The following picture shows different results of the transformer analysis functions.
Attention: The normalized curve is always positive. This has the big advantage that curves with different polarity and curves with the same polarity can be compared.
HIGHVOLT Prftechnik Dresden GmbH - 0808 - 5-62-1-1.doc - Subject to change without prior notice
Print or copy to clip board is always possible. The next picture shows one example.
voltage
current
admittance
phase
Report generator create your report as MS-Word document select the curves for your report freely or filter them by type of evaluation record preview select the columns for your summary table (Up, T1, T2, ) use a MS-Word document as template adjust the no. of pictures per page Report generation dialog
HIGHVOLT Prftechnik Dresden GmbH - 0808 - 5-62-1-1.doc - Subject to change without prior notice
For further information please contact: HIGHVOLT Prftechnik Dresden GmbH Marie-Curie-Strasse 10 D-01139 Dresden / Germany Tel. Fax e-mail website +49 351 8425-648 +49 351 8425-679 dresden@highvolt.de http://www.highvolt.de
HIGHVOLT Prftechnik Dresden GmbH - 0808 - 5-62-1-1.doc - Subject to change without prior notice HIGHVOLT Prftechnik Dresden GmbH - 0808 - 5-62-1-1.doc - Subject to change without prior notice