Instruction Manual: L959 1:12 2WD Off-Road Buggy RC Car
Instruction Manual: L959 1:12 2WD Off-Road Buggy RC Car
Instruction Manual: L959 1:12 2WD Off-Road Buggy RC Car
Specifications
CONTENTS OF THE BOX: SPECIFICATIONS:
• 1 x L959 RC car • 2.4 GHz 2-Wheel drive RC car
• 1 x 2.4 GHz Remote control (4 x AA batteries not included) • Scale: 1:12
• 1 x 7.4V 1500mAh Li-Po battery • Speed: 40+ km/h
• 1 x Charger • Motor: 390 Electric machinery
• 1 x Crossed spanner • Control distance: 100 meters
• 1 x User manual • Li-Po battery: 7.4V 1500mAh
• Charge time: 150 minutes
• Operation time: 10 minutes
• Length: 348mm
• Width: 230mm
• Height: 115mm
• Wheelbase: 250mm
• Wheel span: 170mm
• Wheel diameter: 76mm
• Wheel width: 36mm
Safety precautions
• Read the manual carefully and completely
• This model is not suitable for children under 14 years and contains small parts
• Children should only use this model under the supervision of an adult
• Keep hands, face, hair and clothes away from blades.
• Stand out of reach of moving parts of the copter
• After using the copter ALWAYS disconnect the battery and remove it from the device
• The model and the transmitter must be switched off after use
• Always fly in an open and safe environment where you will not cause any danger to others
• For the remote control, we recommend AA batteries with a voltage of 1.5 to 1.2 volts
• For people without experience, we recommend that you learn to fly with an experienced user during your first flights
• Before each flight, test the distance limit of the transmitter
• Keep these instructions safe
• Always follow local laws and regulations! Contact your reseller when in doubt.
Battery charging
1. LED
2. Li-po Battery
Plug the charger into a wall socket and connect the battery to
the charger. This can only be done in one way: by firmly
connecting the charging cable. If the green light is on, the
battery is fully charged and can be disconnected. Then do not
forget to unplug the charger from the wall socket.
Input : 220V
Charging Current : 500mA
Full Voltage: 4.2 +/- 0.03V
- To turn on the remote control press the power switch (1). The power LED will light up, indicating that the remote controller is
switched on.
- Acceleration and reverse can be controlled by the throttle trigger (3). Pull it backwards to accelerate forwards and push it
forwards to reverse.
- Steering left and right can be controlled by the steering wheel (4).
- If the car has a deviation to the left or right side you can use the steering trim (6) to adjust this deviation.
- If the car slowly drives off while not using the throttle you can use the throttle trim (5) to adjust this deviation.
How to drive
Driving is really simple, but requires some practice. Connect to www.wltoys.eu to watch educational films.
STEERING
The steering wheel serves to steer the RC car to the left or
the right.
CAUTION
- Make sure you never lose the car out of sight when operating.
- Always use a fully charged battery.
- When finished driving, always switch off the car first then the remote control.
- Do not use the RC car when it has visible or mechanical damage.
- Always drive in an area without traffic.
- Never drive towards people or animals.
- Make sure to drive in a controlled and safe environment without obstacles and were no damage can be done.
Adjustments
If the car has deviations regarding the throttle or steering, you can make adjustments by using the trim buttons on the remote. If
the car is accelerates automatically without using the remote, you can use the throttle trim buttons to adjust it. If the car has a
deviation to the left or right when driving, you can use the steering trim buttons on the remote to adjust it.
Note: The car is pre-adjusted in the factory, it is usually not necessary to adjust it when you receive the product.
1. If the car does not operate at all, either the transmitter or receiver is switched off, the batteries are not properly placed or the
batteries are not charged enough. Make sure that the transmitter and receiver are both switched on, the batteries are placed as
described in the manual and the batteries are fully charged in both the transmitter and receiver.
2. If the car does not respond properly, it could be that someone is interfering with the radio frequency that you are using or there
is not enough power in the transmitter or receiver batteries. Switch off the transmitter and receiver and switch them on again to
make a new connection and make sure the batteries in both the receiver and transmitter are fully charged.
3. If the control distance is not reaching the correct distance, the antenna on the transmitter is probably not fully extended or
tightened. Make sure the antenna is fully extended.
Spare parts
The RC car is robust and not very sensitive for crashes, but in case of extreme crashes some parts may break. All parts can be
ordered and easily assembled. Please contact your dealer or visit www.wltoys.eu for more information.
Congratulations on your purchase of this product from wltoys.eu! Wltoys.eu offers its customers a high quality product. All our
products are carefully tested before shipment. If unfortunately a problem persists, contact your dealer or visit www.wltoys.eu. Your
dealer can also assist you in getting spare parts in case you need them. We hope you will enjoy your experience with our product.
WARNING:
Non-compliance with safety rules may cause damage, injury and / or dangerous situations.
Warranty
The use of this product is entirely at your own responsibility and at your own risk. Since we have no control beyond this manual on
when and how you use our product (both flying and maintenance), we are not responsible for any damages or costs incurred by
improper use.
This warranty covers manufacturing and material defects in the context of normal use. We take no responsibility for damage
caused indirectly.