8P-2L6M-D4-V5

8-port sector antenna, 2x 694–960 and 6x 1695–2690 MHz, 65°

HPBW, 4x RET with tilt indicators

4 Independent Arrays (1 Low band and 3 high bands) in a single radome housing
Optimized radome design leading to market leading wind load performance
Antenna with retractable tilt scale indicators and integrated pluggable RET
Uses the 4.3-10 connector which is 40 percent smaller than the 7-16 DIN connector

General Specifications
Antenna Type Sector

Band Multiband

Color Light Gray (RAL 7035)

Grounding Type RF connector inner conductor and body grounded to reflector and mounting
bracket

Performance Note Outdoor usage

Radome Material Fiberglass, UV resistant

Radiator Material Aluminum | Low loss circuit board

Reflector Material Aluminum

RF Connector Interface 4.3-10 Female

RF Connector Location Bottom

RF Connector Quantity, high band 6

RF Connector Quantity, low band 2

RF Connector Quantity, total 8

Remote Electrical Tilt (RET) Information

RET Hardware CommRET v2

RET Interface 2x 8 pin connector as per IEC 60130-9 Daisy chain in: Male / Daisy chain out:
Female Pin3: RS485A(AISG_B), Pin5: RS485B(AISG_A), Pin6: DC 10~30V, Pin7:
DC_ Return

RET Interface, quantity 1 female | 1 male

Input Voltage 10–30 Vdc

Internal RET High band (3) | Low band (1)

Power Consumption, active state, maximum 10 W

Power Consumption, idle state, maximum 2W

3GPP/AISG 2.0 (Single RET) Page 1 of 5

©2023 CommScope, Inc. All rights reserved. CommScope and the CommScope logo are registered trademarks of CommScope and/or its
affiliates in the U.S. and other countries. For additional trademark information see https://www.commscope.com/trademarks. All product names,
trademarks and registered trademarks are property of their respective owners. Revised: October 25, 2023
8P-2L6M-D4-V5
Protocol 3GPP/AISG 2.0 (Single RET)

Dimensions
Width 301 mm | 11.85 in

Depth 181 mm | 7.126 in

Length 2688 mm | 105.827 in

Net Weight, without mounting kit 22.3 kg | 49.163 lb

Array Layout

Port Configuration

Page 2 of 5

©2023 CommScope, Inc. All rights reserved. CommScope and the CommScope logo are registered trademarks of CommScope and/or its
affiliates in the U.S. and other countries. For additional trademark information see https://www.commscope.com/trademarks. All product names,
trademarks and registered trademarks are property of their respective owners. Revised: October 25, 2023
8P-2L6M-D4-V5

Electrical Specifications
Impedance 50 ohm

Operating Frequency Band 1695 – 2690 MHz | 694 – 960 MHz

Polarization ±45°

Total Input Power, maximum 900 W

Electrical Specifications
Frequency Band, MHz 694–790 790–890 890–960 1695–1920 1920–2200 2300–2500 2500–2690
Gain, dBi 16.5 16.7 16.7 17.7 17.9 17.5 17.7
Beamwidth, Horizontal, 70 67 64 65 66 66 63
degrees
Beamwidth, Vertical, degrees 8.3 7.5 7 7.2 6.6 5.8 5.4
Beam Tilt, degrees 0–10 0–10 0–10 2–12 2–12 2–12 2–12
USLS (First Lobe), dB 19 18 18 17 19 20 18
Front-to-Back Ratio at 180°, 30 33 33 36 35 31 33
dB
Front-to-Back Ratio, 30 31 29 31 30 28 28
Copolarization 180° ± 30°, dB
Isolation, Cross Polarization, 27 27 27 27 27 27 27
dB

27 27 27 27 27 27 27 Page 3 of 5

©2023 CommScope, Inc. All rights reserved. CommScope and the CommScope logo are registered trademarks of CommScope and/or its
affiliates in the U.S. and other countries. For additional trademark information see https://www.commscope.com/trademarks. All product names,
trademarks and registered trademarks are property of their respective owners. Revised: October 25, 2023
8P-2L6M-D4-V5
Isolation, Inter-band, dB 27 27 27 27 27 27 27
VSWR | Return loss, dB 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0

PIM, 3rd Order, 2 x 20 W, dBc -150 -150 -150 -150 -150 -150 -150
Input Power per Port, 500 500 500 300 300 250 250
maximum, watts

Electrical Specifications, BASTA

Frequency Band, MHz 694–790 790–890 890–960 1695–1920 1920–2200 2300–2500 2500–2690
Gain by all Beam Tilts, 16.2 16.5 16.4 17.2 17.6 17.1 17.5
average, dBi
Gain by all Beam Tilts ±0.4 ±0.4 ±0.5 ±0.8 ±0.5 ±0.6 ±0.4
Tolerance, dB
Gain by Beam Tilt, average, 0 ° | 16.1 0 ° | 16.6 0 ° | 16.4 2 ° | 17.3 2 ° | 17.7 2 ° | 17.1 2 ° | 17.5
dBi 5 ° | 16.3 5 ° | 16.6 5 ° | 16.6 7 ° | 17.3 7 ° | 17.7 7 ° | 17.3 7 ° | 17.7
10 ° | 16.1 10 ° | 16.1 10 ° | 16.3 12 ° | 16.8 12 ° | 17.3 12 ° | 16.7 12 ° | 16.9

Beamwidth, Horizontal ±1.3 ±1.7 ±2.1 ±5 ±4 ±7.8 ±10.7

Tolerance, degrees
Beamwidth, Vertical ±0.3 ±0.3 ±0.3 ±0.4 ±0.4 ±0.2 ±0.2
Tolerance, degrees
Front-to-Back Total Power at 22 25 25 28 28 26 26
180° ± 30°, dB
CPR at Boresight, dB 20 25 23 19 20 22 22

Mechanical Specifications
Wind Loading @ Velocity, frontal 441.0 N @ 150 km/h (99.1 lbf @ 150 km/h)

Wind Loading @ Velocity, lateral 374.0 N @ 150 km/h (84.1 lbf @ 150 km/h)

Wind Loading @ Velocity, maximum 746.0 N @ 150 km/h (167.7 lbf @ 150 km/h)

Wind Loading @ Velocity, rear 448.0 N @ 150 km/h (100.7 lbf @ 150 km/h)

Wind Speed, maximum 241 km/h (150 mph)

Packaging and Weights

Width, packed 411 mm | 16.181 in

Depth, packed 324 mm | 12.756 in

Length, packed 2814 mm | 110.787 in

Weight, gross 34.9 kg | 76.941 lb

Regulatory Compliance/Certifications
Agency Classification

ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system Page 4 of 5

©2023 CommScope, Inc. All rights reserved. CommScope and the CommScope logo are registered trademarks of CommScope and/or its
affiliates in the U.S. and other countries. For additional trademark information see https://www.commscope.com/trademarks. All product names,
trademarks and registered trademarks are property of their respective owners. Revised: October 25, 2023
8P-2L6M-D4-V5
ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system

Included Products
BSAMNT-3 – Wide Profile Antenna Downtilt Mounting Kit for 2.4 - 4.5 in (60 - 115 mm) OD round members.
Kit contains one scissor top bracket set and one bottom bracket set.

* Footnotes
Performance Note Severe environmental conditions may degrade optimum performance

Page 5 of 5

©2023 CommScope, Inc. All rights reserved. CommScope and the CommScope logo are registered trademarks of CommScope and/or its
affiliates in the U.S. and other countries. For additional trademark information see https://www.commscope.com/trademarks. All product names,
trademarks and registered trademarks are property of their respective owners. Revised: October 25, 2023