JCV4-65B-R6

12-port sector antenna, 2x 703–803, 2x 824-960 and 8x 1695–2690

MHz, 65° HPBW, 6x RETs and low bands have diplexers.

Internal filter on low band and interleaved dipole technology providing for attractive, low wind
load mechanical package

This product will be discontinued on: March 31, 2022

Replaced By:

JCHHTT-65B-R5 12-port sector antenna, 2x 698–803, 2x 824–960, 4x 1695–2180 and 4x 2490-2690 MHz, 65° HPBW,
5x RET. 2500MHz arrays share the same motor.

General Specifications
Antenna Type Sector

Band Multiband

Color Light gray

Grounding Type RF connector body grounded to reflector and mounting bracket

Performance Note Outdoor usage    |   Wind loading figures are validated by wind tunnel
measurements described in white paper WP-112534-EN

Radome Material Fiberglass, UV resistant

Radiator Material Aluminum    |   Low loss circuit board

Reflector Material Aluminum

RF Connector Interface 4.3-10 Female

RF Connector Location Bottom

RF Connector Quantity, high band 8

RF Connector Quantity, low band 4

RF Connector Quantity, total 12

Remote Electrical Tilt (RET) Information

RET Hardware CommRET v2

RET Interface 8-pin DIN Female    |   8-pin DIN Male

RET Interface, quantity 1 female    |   1 male

Page 1 of 5

©2021 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: September 14, 2021
JCV4-65B-R6
Input Voltage 10–30 Vdc

Internal RET High band (4)    |   Low band (2)

Power Consumption, idle state, maximum 1W

Power Consumption, normal conditions, maximum 8W

Protocol 3GPP/AISG 2.0 (Single RET)

Dimensions
Width 350 mm   |   13.78 in

Depth 208 mm   |   8.189 in

Length 1828 mm   |   71.969 in

Net Weight, without mounting kit 34.5 kg   |   76.059 lb

Array Layout

Port Configuration

Page 2 of 5

©2021 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: September 14, 2021
JCV4-65B-R6

Electrical Specifications
Impedance 50 ohm

Operating Frequency Band 1695 – 2690 MHz    |   703 – 803 MHz    |   824 – 960 MHz

Polarization ±45°

Total Input Power, maximum 900 W @ 50 °C

Electrical Specifications
Frequency Band, MHz 703–803 824–896 880–960 1695–1880 1850–1990 1920–2180 2500–2690
Gain, dBi 15 15.4 15.3 15.5 15.7 16.1 16.1
Beamwidth, Horizontal, 67 65 64 62 61 60 63
degrees
Beamwidth, Vertical, degrees 12 10.7 10 11.2 10.6 10 8.3
Beam Tilt, degrees 2–14 2–14 2–14 2–14 2–14 2–14 2–14
USLS (First Lobe), dB 21 20 16 17 18 18 16
Front-to-Back Ratio at 180°, 32 34 33 35 37 35 34
dB
Isolation, Cross Polarization, 25 25 25 25 25 25 25
dB
Isolation, Inter-band, dB 30 30 30 30 30 30 30
VSWR | Return loss, dB 1.46 | 14.5 1.46 | 14.5 1.46 | 14.5 1.46 | 14.5 1.46 | 14.5 1.46 | 14.5 1.46 | 14.5

-150 -150 -150 -150 -150 -150 -150 Page 3 of 5

©2021 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: September 14, 2021
JCV4-65B-R6
PIM, 3rd Order, 2 x 20 W, dBc -150 -150 -150 -150 -150 -150 -150
Input Power per Port at 50°C, 200 200 200 250 250 250 200
maximum, watts

Electrical Specifications, BASTA

Frequency Band, MHz 703–803 824–896 880–960 1695–1880 1850–1990 1920–2180 2500–2690
Gain by all Beam Tilts, 14.8 15.3 15.1 15.1 15.5 15.7 15.7
average, dBi
Gain by all Beam Tilts ±0.3 ±0.3 ±0.5 ±0.6 ±0.3 ±0.4 ±0.6
Tolerance, dB
Gain by Beam Tilt, average, 2 ° | 14.7 2 ° | 15.3 2 ° | 15.3 2 ° | 15.2 2 ° | 15.6 2 ° | 15.8 2 ° | 15.8
dBi 8 ° | 14.8 8 ° | 15.4 8 ° | 15.3 8 ° | 15.2 8 ° | 15.6 8 ° | 15.8 8 ° | 15.8
14 ° | 14.6 14 ° | 15.0 14 ° | 14.6 14 ° | 15.0 14 ° | 15.4 14 ° | 15.6 14 ° | 15.4

Beamwidth, Horizontal ±1.7 ±1.2 ±3.5 ±3.5 ±2.4 ±2.8 ±4.9

Tolerance, degrees
Beamwidth, Vertical ±0.8 ±0.5 ±0.7 ±0.7 ±0.6 ±0.8 ±0.6
Tolerance, degrees
USLS, beampeak to 20° above 21 19 16 17 18 18 15
beampeak, dB
Front-to-Back Total Power at 25 24 24 27 28 26 26
180° ± 30°, dB
CPR at Boresight, dB 18 17 17 19 20 20 17
CPR at Sector, dB 10 11 9 10 8 9 6

Mechanical Specifications
Wind Loading @ Velocity, frontal 301.0 N @ 150 km/h (67.7 lbf @ 150 km/h)

Wind Loading @ Velocity, lateral 254.0 N @ 150 km/h (57.1 lbf @ 150 km/h)

Wind Loading @ Velocity, maximum 638.0 N @ 150 km/h (143.4 lbf @ 150 km/h)

Wind Loading @ Velocity, rear 319.0 N @ 150 km/h (71.7 lbf @ 150 km/h)

Wind Speed, maximum 241 km/h   |   149.75 mph

Packaging and Weights

Width, packed 450 mm   |   17.717 in

Depth, packed 355 mm   |   13.976 in

Length, packed 1975 mm   |   77.756 in

Weight, gross 47.8 kg   |   105.381 lb

Regulatory Compliance/Certifications
Agency Classification
Page 4 of 5

©2021 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: September 14, 2021
JCV4-65B-R6
ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system

Included Products
BSAMNT-3 – Wide Profile Antenna Downtilt Mounting Kit for 2.4 - 4.5 in (60 - 115 mm) OD round members.
Kit contains one scissor top bracket set and one bottom bracket set.

* Footnotes
Performance Note Severe environmental conditions may degrade optimum performance

Page 5 of 5

©2021 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: September 14, 2021