Power Outlet: Section
Power Outlet: Section
Power Outlet: Section
E
CONTENTS
COMPONENT DIAGNOSIS .......................... 2 ON-VEHICLE REPAIR .................................. 5 F
PWO
JCMWA3233GB
PWO
JCMWA3234GB
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS
system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front
air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.
Information necessary to service the system safely is included in the “SRS AIRBAG” and “SEAT BELT” of this
Service Manual.
WARNING:
• To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in
the event of a collision which would result in air bag inflation, all maintenance must be performed by
an authorized NISSAN/INFINITI dealer.
• Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal
injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag
Module, see the “SRS AIRBAG”.
• Never use electrical test equipment on any circuit related to the SRS unless instructed to in this Ser-
vice Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness
connectors.
PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS
When working near the Airbag Diagnosis Sensor Unit or other Airbag System sensors while ignition switch is
ON or engine is running, never use air or electric power tools or strike near the sensor(s) with a hammer.
Heavy vibration may activate the sensor(s), deploy the airbag(s), possibly cause serious injury.
When using air or electric power tools or hammers, always turn OFF ignition switch, disconnect the battery,
and wait 3 minutes or more before performing any service.
Precaution for Battery Service INFOID:0000000004694620
Before disconnecting the battery, lower both the driver and passenger windows. This will prevent any interfer-
ence between the window edge and the vehicle when the door is opened/closed. During normal operation, the
window slightly raises and lowers automatically to prevent any window to vehicle interference. The automatic
window function will not work with the battery disconnected.
C
1 : Inner socket
2 : Ring
D
3 : Power socket finisher
JPMIA1319ZZ
F
FRONT POWER SOCKET : Removal and Installation INFOID:0000000004490847
REMOVAL G
JPMIA1327ZZ
2. Pull out inner socket (1) by pushing the ring pawl (A) from the K
inner socket hole (square) (B).
C : Cut out L
3. Remove ring (2) from power socket finisher (3).
PWO
JPMIA1320ZZ
N
INSTALLATION
Install in the reverse order of removal.
NOTE: O
Align the cut outs of inner socket, ring, and power socket finisher.
CONSOLE POWER SOCKET
P
1 : Inner socket
2 : Ring
JPMIA1321ZZ
REMOVAL
1. Remove console pocket assembly. Refer to IP-22, "Exploded View".
2. Disconnect power socket connector (A).
B : Cut out
3. Pull out inner socket (1) by pushing the ring pawl (C) from the
inner socket hole (square) (D).
4. Remove ring (2) from console pocket assembly while pressing
pawls.
JPMIA1322ZZ
INSTALLATION
Install in the reverse order of removal.
NOTE:
Align the cut outs of inner socket, ring, and console pocket assembly.