Vp-15-109-001-A01-P-237-004abc-D-008 Data Sheet For Main Motor
Vp-15-109-001-A01-P-237-004abc-D-008 Data Sheet For Main Motor
Vp-15-109-001-A01-P-237-004abc-D-008 Data Sheet For Main Motor
CA/CSPD/0009
JUL.09, 2012
FOR APPROVAL DONDYANG
CHEMICAL
PUMP CO.LTD.
TOTAL 5 PAGES
OTHER REQUIREMENTS
53 Acceleration time: 76 Shaft design for torsional analysis
Motor only rated volts : 3.8 sec 77 Axial tolerance
Motor load 80% volts : 8.4 sec 78 Stress: Axial Lb Radial Lb
54 Proposed temperature class : T3 79 Terminal box thread size:
55 Maximum noise level proposed : 80+3 dB (A) 80 Curves required based on motor
56 Dimensions: saturation at rated voltage
Shaft Dia. later inches Key later inches Speed vs torque (also rated voltage)
57 Weight total 4120 Rotor 780 Speed vs power factor
58 Maximum moment on base later Lb-ft. Speed vs current
59 End play later Speed vs time (acceleration)
60 Terminal box fault withstand MVA/sec later Time vs current (heating curve)
ACCESSORY EQUIPMENT SHOP INSPECTION & TESTS
o Required Witness
61 Space heaters Max. sheath C 81
400 watts 230 volts 3 phase 50 hertz Yes No 1
62 Main terminal box size for: High voltage test plus
Main motor load later insulation resistance test
Stress cones later Measurement of:
63 Winding temperature detectors - No-load current
RTD: 6pcs PT100 No./phase 2 - Locked rotor current
PT:100 ohms at oC - Winding resistance
64 Thermocouple No./phase - Slip at load
Type - Torque at load
65 Thermistors No./phase - Starting torque
66 Thermal temperature switch: No./phase - Efficiency & power
N.O. contact factor
N.C. contact - Power factor at starting
67 Bearing temperature devices RTD's - Heat run test
Thermocouple type Alarm contacts - Vibration test at
Dial type thermometers full speed
o o
Set later C Alarm later C S/D - Noise level test
68 Differential protection NOTE
Neutral terminal box sized for CT 1. Inspection and Tests shall meet the requirements of “General
CT (by others) description Inspection requirement LPG4-PGP-007” as a minimum.
69
70 Vibration devices
Process drilling only
Process Installed: Type
Switch Manual reset
Electrical reset
71
72
73
74
75