Generic Heavy Equipment Operator SOP
Generic Heavy Equipment Operator SOP
Generic Heavy Equipment Operator SOP
Hardhat and high-visibility clothing to be worn when not inside the cab.
Safety boots in good condition, properly laced, must be worn at all times. Worn-out
soles and heels could lead to slips and falls.
Eye protection will be worn where there is danger of falling or flying debris from
equipment or loads, especially in windy conditions.
Hand protection will be worn when handling cable or any other material where there
is danger of cuts or puncture injury.
Hearing protection will be worn when exposed to noise levels exceeding 85dBA.
When working around equipment for inspections or repairs, the equipment must be
locked and tagged out, and immobilized and secured against inadvertent movement.
4. Housekeeping – cabs, steps, windshields, windows and mirrors must be kept clean
at all times. All debris should be removed from around the equipment.
6. Travelling – operators must ensure that all connections to a towing vehicle are
secured and attached properly.
Travelling on hills should be conducted in the direction of the slope, avoiding side hill
travel.
Approach landing or roadway with caution taking into consideration limited visibility
and blind spots.
Keep right while traveling on en route to and from work site, while maintaining radio
communication.
7. Danger zone – danger zone is defined as the area around operating machines or
working personnel, in which there is potential for being struck by moving equipment
or objects. The danger zone may vary according to the machine or work being
performed. Operators must make sure that all persons, vehicles and equipment are
clear of the danger zone before the vehicle or its components are moved.
d) Ensuring that it is safe to resume working and that all guards are in place.
The operator must have a clear understanding of what is to be done and follow the
specific lockout instructions and instructions given by the mechanic responsible for
performing the job.
9. Fuelling – shut off the engine of the towing vehicle while it’s being fuelled. No
smoking. Be aware of slip and trip hazards.
Beware of spills and splash-back. Return hose to its proper storage position when
fuelling completed.
10. Hazardous materials – read WHMIS label. If there is no label, contact the
supervisor. Refer to MSDS if further information is needed.
Prior to starting heavy equipment, the operator shall ensure that all personnel are
out of the danger zone and the transmission is in neutral.
Understand the load limitation of the machine according to ground conditions and
tree species. Apply the manufacturer’s standards for machine capacity and
limitations. The operator should always know the maximum lifting capacity of the
equipment before lifting a load.
In the event of leak of fuel or oil, switch the machine off immediately.
If warning lights show or gauges register outside normal limits, switch off engine.
Never lift, move or swing any attachments or load over any person or other
equipment/vehicles.
By signing below, both parties agree that all of the above items have been discussed
and understood