ARCODE Priority Service Mode V10.En
ARCODE Priority Service Mode V10.En
ARCODE Priority Service Mode V10.En
This document defines the operating of ARCODE lift driver during “Priority Service Function”.
Priority Service Function is used to send the lift car to a specific floor as soon as possible
without considering other car calls by triggering with a special key or electronic identity card
during the operating of lift normally. This function is generally used in hospitals.
1. Common Operation
Priority Service Function starts by getting signal from any of the programmable inputs of
(PRIA.x) or (PRIB.x). (x: the floor number of priority service call)
Output (PRAC) becomes active as long as the function is active. According to the following
parameter choices the car is send to “floor x” directly or after completing all the car calls.
While landing on the floor, the lift quits from priority service function whenever the
conditions defined again with parameters are provided.
(Priority service function is cancelled by taking an error from the controller; by operating
with inspection mode, recall mode, evacuation electrically, fire and earthquake mode)
2. The Parameters Regarding Priority Service Function
The operation type of priority service function can be customised according to the
requirements of the building with the following parameters which are in Arcode parameter
list.
However, if parameter (P0882) is chosen as “Existing car calls are not cancelled, new call is
not received”, regardless of parameter (P0883) it lands on the floors which have existing car
commands and the doors are open.
The vatman key must be assigned to the programmable input called “97: (VAT) Vatman
signal”.