Nothing Special   »   [go: up one dir, main page]

You Are Required To

Download as docx, pdf, or txt
Download as docx, pdf, or txt
You are on page 1of 2

In this part of the laboratory, you will be required to design a power amplifier to drive an 8ohm,

6-watt speaker. To help you get started a schematic of the amplifier that you are going to design
is given in the figure below.
You are required to:
1. Make any modification that you think are needed.
2. Calculate the gain and resistor values for both stages of the amplifier.
3. Construct the amplifier on bread board, check if the amplifier works, measure the voltage gain
of each amplifier.
4. Construct the amplifier on vero board. All calculations and design work must be neatly
presented in your log book.
The signal in will simply be a sine wave.

If it's possible, could you make sure the values of the capacitors do not exceed to around a 1000
or more microFarad.
I'm really stuck and need an answer to this question as soon as possible~ Thank you~
http://www.chegg.com/homework-help/questions-and-answers/required-designpower-amplifier-drive-speaker-help-get-started-schematic-amplifier-going-dq5427878?trackid=5a616032&strackid=7fe01901&ii=4

You might also like