Ergime Sıcaklığı 100 Derece Olan Polietilen
Ergime Sıcaklığı 100 Derece Olan Polietilen
Ergime Sıcaklığı 100 Derece Olan Polietilen
PL3620
PoLinker PL3620 resin is a grafted coupling agent based on
low density polyethylene which combines functional groups
by using reactive extrusion. PL3620 resin can improve the
polarity of the plastic to increase the compatibility between
different materials.
Test Method
Unit
Value
HARDNESS
Shore A
ASTM D2240
Shore D
ASTM D2240
44
THERMAL
Vicat Soften Temp.
ASTM D1525
80
Melting Temp
ASTM D3418
100
Density
ASTM D792
ASTM D1238
g/10min
PHYSICAL
Polyalloy Method
0.916
10
High
Additional information
The mechanical properties of end products will be affected by adding ratio of PoLinker. The Heat Deflection Temperature
(HDT) may be decreased by adding PoLinker PL3620 to engineering plastics. PL3620 resin may affect the flammability of
end products. All PoLinker resins are not recommended to be processed to the products which will contact the foods
immediately.
(1)
Values shown are based upon specific condition. Variations within normal tolerances are possible for various colors. Actual properties of individual batches
will vary within specification limits.
Reported values are only as guidelines for designers and processors of modified thermoplastics. Data are obtained from specimens molded under carefully
controlled conditions from representative samples of the compound described herein. Properties may be materially affected by pellet cut, size, color, molding
techniques applied, and shape of the item molded. No assurance can be implied that all molded articles will have the same properties as those listed.
The values of specification listed were collected and shown to the best of our knowledge. However, we ask for understanding that we can not take o
ver liability for the results in individual cases and for the suitability and completeness of our recommendations, and can not guarantee that no third-p
arty patent rights are restricted. It is the responsibility of the customer to determine that the product is safe, lawful and technically suitable for the int
ended use.
Polyalloy Incoporation
www.polyalloy.com.tw
Technical Datasheet
Packaging and Drying
Product Safety
500
750
1,000
+ (886) 3483-8475
Storage
Please store Polinker resins indoor with room temperature.
Avoid to be in touch with water, oil or solvent. Specific
grades of Polinker must be stored at the environment no
more than 45C. The dust of package may cause contamination when it be opened. Supplied packaging should be
kept closed and undamaged. Partial bags should be sealed
before re-storage.
The Polinker resins contain funtionalized additives to
perform its properties, long term storage may affect the
benefit of resins which is not recommended. The normal
storage warranty will be 2 years.
Regrind
Reported values are only as guidelines for designers and processors of modified thermoplastics. Data are obtained from specimens molded under carefully
controlled conditions from representative samples of the compound described herein. Properties may be materially affected by pellet cut, size, color, molding
techniques applied, and shape of the item molded. No assurance can be implied that all molded articles will have the same properties as those listed.
The values of specification listed were collected and shown to the best of our knowledge. However, we ask for understanding that we can not take o
ver liability for the results in individual cases and for the suitability and completeness of our recommendations, and can not guarantee that no third-p
arty patent rights are restricted. It is the responsibility of the customer to determine that the product is safe, lawful and technically suitable for the int
ended use.
Polyalloy Incoporation
www.polyalloy.com.tw