Nothing Special   »   [go: up one dir, main page]

Utc1869 Yw

Download as pdf or txt
Download as pdf or txt
You are on page 1of 7

UTC1869 LINEAR INTEGRATED CIRCUIT

HIGH FREQUENCY PWM


CONTROLLER

DESCRIPTION
The UTC1869 is a high frequency PWM controller integrates
required functions for boost conversion in a small SOP-8
package . A low 0.21V feedback voltage make the UTC1869
be an ideal contoller for LED backlight supplies .
SOP-8

FEATURES
* Voltage Mode PWM Controller
* Low 0.21V reference Voltage
* 180KHz Operation
* Deadtime Control
* Internal UVLO(Under Voltage Lock Out)
* Limited Output Duty Cycle
* Low Shutdown current
* SOP-8 Package
* Soft Setup

ABSOLUTE MAXIMUM RATINGS


(Unless otherwise noted ,all is over operating free-air temperature Range)
Characteristic Value Unit
Supply Voltage 7-40 V
Input Voltage -0.3 Vcc+0.3 V
Operating Ambit Temperature Range 0 70 °C
Extreme Operating Ambient Temp -40 85 °C
Operating Junction Temperature +150 °C
Storage Temperature -55 150 °C

RECOMMENDED OPERATING CONDITION


Characteristic Value Unit
Supply Voltage 36 V
Operating Ambient Temperature 0 70 °C

BLOCK DIAGRAM

YOUWANG ELECTRONICS CO.LTD 2012.07.11 V1.6


1
UTC1869 LINEAR INTEGRATED CIRCUIT
PIN CONFIGURATIONS

PIN FUNCTIONS
Pin No. Pin Name Function
1 IN Sampling signal input
2 FB Feedback PWM input
3 DT Deadtime Control
4 GND GND
5 OUT PWM output
6 VCC Power supply
7 EA Enable
8 Vref Internal 5V reference

YOUWANG ELECTRONICS CO.LTD 2012.07.11 V1.6


2
UTC1869 LINEAR INTEGRATED CIRCUIT
ELECTRICAL CHARACTERISTICS
(Over recommended operating free-air temperature range,V CC=12V,Unless otherwise specified)
Characteristic Test Conditions Min Typ Max Unit
Reference Section
Feedback voltage 0.21 V
Output voltage Io=1mA 5 V
Input regulation Vcc=7V to 36V 2 50 mV
Output Regulation Io=1 to 10mA 1 15 mV
Output Voltage change with ∆TA=MIN to MAX(note 2) 0.2 1 %
Temperature
Short-circuit output Current Vref=0 35 mA
Characteristic Test Conditions Min Typ Max Unit
Oscillator section
Frequency 180 kHz
Standard Deviation of Frequency 20 %
Amplifier Section
Input offset Voltage Vo(pin 2)=2.5V 2 10 mV
Input offset Current Vo(pin 2)=2.5V 25 250 nA
Input bias Current Vo(pin 2)=2.5V 0.2 1 µA
Input Voltage Range Vcc=7V to 25 V -0.3 to V
Vcc-2
Open-Loop Voltage Amplification ∆Vo=3V, Vo=0.5V to 3.5V 70 95 dB
Unity-Gain Bandwidth 800 kHz
Rejection ratio Vcc=25V,TA=25°C 65 80 dB
Output Section
VOUT Low 0.1 0.3 V
High Io= -200mA VCC-1.5 VCC-2.5 V
Dead Time Control Section
Maximum duty cycle,each output VI(pin 3)=0 85 %
Input threshold Voltage(pin3) Zero duty Cycle 3 3.3 V
Maximum duty cycle 0 V
Grounding resistance 80 k
PWM comparator Section
Input Threshold Voltage(pin 2) Zero Duty cycle 0.1 0.2 V
Input sink current (pin 2) Vpin 2= 0.7V 0.3 0.7 mA
Total Device
Standby supply current Vcc=12V All Inputs and outputs open 6 10 mA
Vcc=25V EA High 9 15 mA
EA Low 0.1 mA
Under Voltage Look Out
Upper threshold voltage Ta=2 6.2 6.4 6.6 V
Switching Characteristics,Ta=25°C
Output Voltage rise time 100 200 ns
Output Voltage fall time 100 200 ns
EA Section
Enable Low 0 0.2 V
High 2 5 V
EA Grounding resistance 20 k

note 1:All typical Values except for temperature coefficient are at Ta=25°C.
note 2:For conditions shown as MIN or MAX, use appropriate value under recommended operating conditions.
note 3:Duration of the short-circuit should not exceed one second.

YOUWANG ELECTRONICS CO.LTD 2012.07.11 V1.6


3
UTC1869 LINEAR INTEGRATED CIRCUIT

TYPICAL APPLICATION CIRCUI

YOUWANG ELECTRONICS CO.LTD 2012.07.11 V1.6


4
UTC1869 LINEAR INTEGRATED CIRCUIT

TYPICAL APPLICATION CIRCUI

YOUWANG ELECTRONICS CO.LTD 2012.07.11 V1.6


5
UTC1869 LINEAR INTEGRATED CIRCUIT

TYPICAL PERFORMANCE CHARACTERISTICS


VIN=12V 14 LEDs in series, 200mA / string, unless otherwise noted.

YOUWANG ELECTRONICS CO.LTD 2012.07.11 V1.6


6
UTC1869 LINEAR INTEGRATED CIRCUIT

PACKAGE DIMENSIONS
SOP-8-225-1.27 Unit: mm

YOUWANG ELECTRONICS CO.LTD 2012.07.11 V1.6


7

You might also like