Eminence - Subwoofer 12inch
Eminence - Subwoofer 12inch
Eminence - Subwoofer 12inch
Mounting Information
Recommended Enclosure Volume
Sealed 22.7-28.3 liters/ 0.8-1 cu.ft.
Vented 45.3-101.9 liters/1.6-3.6 cu.ft.
Overall Diameter 12.32”, 312.8mm
Baffle Hole Diameter 10.98”, 278.9mm
Front Sealing Gasket fitted as standard
Rear Sealing Gasket fitted as standard
Mounting Holes Diameter 0.26”, 6.6mm
Mounting Holes B.C.D. 11.77”, 299mm
Depth 6.44”, 164mm
Net Weight 22 lbs., 10 kg
Shipping Weight 23.8 lbs., 10.8 kg
Materials of Construction
Copper voice coil
Polyimide former
Double stacked 80 oz. ferrite magnets
Vented and extended core
* Please inquire about alternative impedances.
12-spoke die-cast aluminum basket
** Multiple units exceed published rating evaluated under EIA 426A noise source and test standard while in a free-air, non-temperature controlled environment.
Kevlar-reinforced paper cone *** The average output across the usable frequency range when applying 1W/1M into the nominal impedance. Ie: 2.83V/8ohms, 4V/16ohms.
Foam cone edge Eminence response curves are measured under the following conditions: All speakers are tested at 1w/1m using a variety of test set-ups for the appropriate impedance | LMS using 0.25” supplied microphone (software
Dual inverted dust caps calibrated) mounted 1m from wall/baffle | 2ft. X 2ft. baffle is built into the wall with the speaker mounted flush against a steel ring for minimum diffraction | Hafler P1500 Trans-Nova amplifier | 2700 cu.ft. chamber with
fiberglass on all six surfaces (three with custom-made wedges)