vn330sp e
vn330sp e
vn330sp e
Datasheet
Features
• Output current: 0.7 A per channel
• Digital input clamped at 32 V minimum voltage
• Shorted load and overtemperature protections
• Built-in current limiter
• Undervoltage shutdown
• Open drain diagnostic output
• Fast demagnetization of inductive loads
• Conforms to IEC 61131-2
Description
The VN330SP-E is a monolithic device developed using VIPower technology,
intended to drive four independent resistive or inductive loads with one side
connected to ground. Active current limitation prevents dropping of the system
power supply in case of shorted load. Built-in thermal shutdown protects the chip
from overtemperature and short-circuit. The open drain diagnostic output indicates
overtemperature conditions.
1 Block diagram
2 Pin connection
3 Maximum ratings
1. Per channel.
2. When mounted on a four-layer FR-4, with the minimum recommended pad size.
4 Electrical characteristics
10 V < VCC < 36 V; -40 °C < TJ < 125 °C; unless otherwise specified
Vdemag Output voltage at turn-off IOUT = 0.5 A; LLOAD ≥ 1 mH VCC-65 VCC-55 VCC-45 V
Table 4. Switching (VCC = 24 V, RLOAD = 48Ω, see Figure 8. Switching parameter test conditions)
Normal operation 2
(di/dt)off Turn-off current slope A/µs
IOUT = ILIM, TJ = 25 °C 4
IIN = 1 mA 32 36
VICL Input clamp voltage(1) V
IIN = -1 mA -0.7
1. The input voltage is internally clamped at 32 V minimum, the input pins can be connected to a higher voltage by an external
resistor, which cannot exceed 10 mA
IDIAG = 1 mA 32 36 V
VSCL (1) Status clamp voltage
IDIAG = -1 mA -0.7
VCC = 24 V; VIN = 30 V;
IOVPK Peak short-circuit current 4 A
RLOAD < 10 mΩ
Thermal shutdown
TTSD 150 170 °C
temperature
TR Thermal reset temperature 135 155 °C
Note: If the INPUT pin is left floating, the corresponding channel automatically switches off. If GND pin is
disconnected, the channel switches off provided that VCC does not exceed 36 V.
5 Test circuits
L L H
Normal operation
H H H
L L H
Overtemperature
H L L
L L H (1)
Undervoltage
H L H (1)
L L H
Shorted load (current limitation)
H H (2) H
7 Package information
In order to meet environmental requirements, ST offers these devices in different grades of ECOPACK packages,
depending on their level of environmental compliance. ECOPACK specifications, grade definitions and product
status are available at: www.st.com. ECOPACK is an ST trademark.
mm
Dim.
Min. Typ. Max.
A1 0 0.05 0.1
A2 3.4 3.5 3.6
A3 1.2 1.3 1.4
A4 0.15 0.2 0.25
a 0.2
b 0.37 0.45 0.53
c 0.23 0.27 0.32
D 9.4 9.5 9.6
D1 7.4 7.5 7.6
d 0 0.05 0.1
E 13.85 14.1 14.35
1. Resin protrusions are not included (max. value 0.15 mm per side)
mm
Dim.
Min. Typ. Max.
mm
Dim.
Min. Typ. Max.
A 330
B 1.5
C 12.8 13 13.2
D 20.2
N 60
G 23.7 24.4
T 30.4
Table 11. PowerSO-10 base and bulk quantity in tape and reel
600 600
Figure 12. PowerSO-10 suggested pad and tube shipment (no suffix)
8 Ordering information
VN330SP-E Tube
PowerSO-10
VN330SPTR-E Tape and reel
Revision history
Table 13. Document revision history
Contents
1 Block diagram . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
2 Pin connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
3 Maximum ratings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
4 Electrical characteristics. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
5 Test circuits . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
6 Switching time waveforms and truth table. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
7 Package information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11
7.1 PowerSO-10 package information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
7.2 PowerSO-10 packing information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
8 Ordering information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16
Revision history . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .17
List of tables . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .19
List of figures. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .20
List of tables
Table 1. Absolute maximum ratings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Table 2. Thermal data. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Table 3. Power section . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Table 4. Switching (VCC = 24 V, RLOAD = 48Ω, see Figure 8. Switching parameter test conditions) . . . . . . . . . . . . . . . 6
Table 5. Logic inputs. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Table 6. Protection and diagnostic . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Table 7. Truth table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Table 8. PowerSO-10 package mechanical data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Table 9. PowerSO-10 career tape dimension mechanical data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
Table 10. PowerSO-10 reel dimension mechanical data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Table 11. PowerSO-10 base and bulk quantity in tape and reel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Table 12. Ordering information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
Table 13. Document revision history . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
List of figures
Figure 1. Block diagram . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Figure 2. Connection diagram (top view) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Figure 3. Current and voltage conventions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Figure 4. Avalanche energy test circuit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Figure 5. Peak short-circuit test diagram . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Figure 6. Switching waveforms. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Figure 7. Switching parameter test conditions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Figure 8. Driving circuit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Figure 9. PowerSO-10 package outline . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Figure 10. PowerSO-10 career tape outline . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
Figure 11. PowerSO-10 reel outline . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Figure 12. PowerSO-10 suggested pad and tube shipment (no suffix) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15