Denso Butyl S43HT R23 Tape System Rev-01
Denso Butyl S43HT R23 Tape System Rev-01
Denso Butyl S43HT R23 Tape System Rev-01
The Denso S43HT /R23 System is designed for the corrosion prevention of
pipeline, joints, welds, bends and fittings.
Denso Butyl Primer P16HT should be applied to the prepared surface at a rate
PRIMER
of 6m²/lt and allowed to tack dry.
Denso Butyl Mastic Strip should be used to contour weldbeads and step down
PROFILING on the shop coating (where applicable).
Denso S43HT Tape can be applied either by hand or the Densoman Wrapping
INERWRAP Machine with a minimum overlap of 55% with the Grey Adhesive side applied
onto the prepared surface.
Denso R23 Tape must be applied with the 55% overlap onto the Black outer
OUTERWRAP
adhesive surface of the S43HT innerwrap Tape.
Normal hygiene procedures. Wash hands thoroughly with soap and water or a
SAFETY
proprietary hand-cleaner prior to eating. Launder contaminated clothing,
gloves, etc.
Store in original containers in a cool, dry place away from and sources of
STORAGE ignition.
Wrapped pipe should not be left exposed to direct sunlight for longer than
fourteen (14) days.
Document Reference: TDSRP3-1 Rev:02
DENSO BUTYL S43HT / R23 TAPE SYSTEM (Cont).
Peel Strength
Peel Strength
Peel Strength
Peel Strength
Peel Strength
Important
Winn & Coales / Denso SA (Pty) Ltd pursue a policy to develop and continually improve all of our products and therefore the
information given in this data sheet is intended as a general guide and does not constitute a warranty of specificatio n. However,
our sales personnel are committed to assist the user in establishing the suitability of the product for its intended purpose and
additional specific information is available on request.
Denso SA (Pty) Ltd operate a Quality Management System registered to ISO 9001:2008.