Alccocoat (GP) - White Base
Alccocoat (GP) - White Base
Alccocoat (GP) - White Base
alccocoat (GP)
Revision No R-02
alccocoat (GP) is a general purpose polymer Bond between concrete and cement plaster
modified cementitious coat requiring addition of Bond between concrete and gypsum plaster
only water at site. It is composed of white Bond between concrete and ceramic /glaze
tile.
cement, properly selected fine aggregates and
Bond between new and old concrete.
microfine additives. It is suitable for any
substrate. It can be used for both internal as well Technical Data
as external applications
Item Description Test Results
Product Features Type Polymer Modified bond coat
Appearance Off White Granular Powder
Provides excellent adhesion bond to substrate MAS 3.0 mm
Dual bonding effect of chemical and pH 9-11
mechanical bond
Water Mixing Ratio 50-60% of powder (can vary based
Premixed accurately in specified proportions on climatic conditions)
Consistent performance in each and every Application < 35°C
bag Temperature
Contains right blend of polymers for Pull off strength 0.3-0.6 N/mm2
significantly improved performance Pot Life >30 mins [ can vary based on
climatic conditions]
coverage Approx. 20 Sqft / kg on RCC wall -
Product Advantages Coverage may depend on
application method and substrate
No hacking of surface is required - saves time
and cost
Provides excellent base to receive plaster Surface Preparations
even on very smooth surfaces
Easy to use only water to be added at site The substrate surface should to Clean, dust free
Easy application with brush or roller and free from traces of oil or chemicals
Minimizes wastage due to less rebound
The surface has to be dampened with potable
water before application (without any surface
Typical Uses
water or Moisture)
alccocoat (GP) can be used for many applications
including but not limited to following application
Alccotech Building Materials Pvt Ltd Page 1 of 2
710 B Wing Loadha Supremus II Road # 22 Wagle Industrial Estate Thane W – 400604
www.alccotech.com
TECHNICAL DATA SHEET
ALCCOTECH BUILDING MATERIALS PVT LTD
Mixing and Application Safety
1. Use efficient mixer or blender (preferably The use of dust masks, safety goggles, and gloves
PAN Mixer) for mixing is recommended
2. Charge 80-90 % of mixing water (14.5 to 16
litres per 30 kg bag)
3. Start addition of alccocoat powder slowly
under continuous mixing to the Mixer and mix
for 1 minute.
4. Add balance quantity (20 – 10 %) of mixing
water & again mix for another 2-3 minutes to
form a homogeneous, free flowing, uniform
mix.
5. Simply apply the thin uniform layer preferably
by roller or brush on the desired surface as
soon as possible from mixing
6. Once the applied coat is about to dry
completely, it is ready to receive plaster
Precautions
Not required