Technical Drawing Firewatcher 106
Technical Drawing Firewatcher 106
Technical Drawing Firewatcher 106
FW106
DESCRIPTION
FireWatcher FW1 is an addressable Fire Alarm Control Panel designed for small to medium-scale facilities. It is ideally
suited for both new and retrofit commercial, institutional, and industrial fire detection and notification
applications.FireWatcher FW1 is a state‐of‐the‐art addressable fire control system that meets the requirements of UL864
10th edition, and ULC S527. It can support 1 addressable Loop Signalling Line Circuits and 252 addressable devices/points,
with 4 Notification Appliance Circuits and 4 form C dry relay contacts.The FW1 has a 7’’ LCD with 800 X 480 resolution, 6
auxiliary function keys and 9 LED indicators making it a highly intuitive fire alarm user interface. It can also be connected
to 109 remote annunciators via an external network to form a fire emergency detection and notification network system.
ATTENTION
Products must be installed in accordance with the National Fire Alarm Code, NFPA 72, CAN / ULC-S524 and / or National Electrical Code, depending on the country of
installation. Check information on equipment used in the system from other manufacturers for instructions and restrictions. The detector should never
be installed in the following places: where there is a lot of exhaust gas, kitchens, near fireplaces, boilers, etc. Smoke detectors should not be used with
detector guards unless the suit has been evaluated and approved for this case.
NOTE
Do not paint this unit. Any material extrapolated from this document or Maple Armor's instructions or other materials describing the product for promotional or
advertising purposes, or for any other purpose, including the description of the application. , the use, installation and testing of the product is the sole responsibility of
the user. Maple Armor assumes no responsibility for the use. In no event shall Maple Armor's liability exceed the purchase price of the product.
Page 1 sur 4
FW106
INSTALLATION
Page 2 sur 4
FW106
SPECIFICATION
General Digital signal processor-based design, fully configurable from front panel with password protection
Notification Appliance Circuits "Class A/ Class B circuit Bell code: ANSI Temporal
4 + 4 circuits per panel
2 Amp per NAC
Supervised wiring
Synchronized Outputs"
Addressable Loop Circuits "Maximum Current (Short): 0.4A
Class A/ Class B circuit
252 addresses: detectors and modules max
Output voltage range: 20.4V - 28V
Normal standby current: 100mA / Alarm current: 220mA
Up to 4 loops per panel"
Page 3 sur 4
FW106
CATALOG NUMBERS TO ORDER
Modèle Description
Page 4 sur 4
FW106