Calibration Using Caterpillar Electronic Technician: SMCS - 7610-524-MCH
Calibration Using Caterpillar Electronic Technician: SMCS - 7610-524-MCH
Calibration Using Caterpillar Electronic Technician: SMCS - 7610-524-MCH
Page 1 of 6
Shutdown SIS
Previous Screen
! "#$ % &'
( ) * +
,-
.
."//.,
Calibration
SMCS - 7610-524-MCH
Similar procedures for calibration may also be performed through the Monitoring System. See Systems
Operation, RENR8068, "Calibration Mode".
The calibration menu is used in order to compensate for the differences in the mechanical components
and the electrical components. The calibration should be performed if the ECM has been replaced or the
ECM was removed. The calibration should be performed if components have been replaced or removed.
Perform all calibrations that are applicable.
Note: Be sure the hydraulic oil temperature is at least 50 °C (122 °F) before performing calibrations.
Accessing Calibrations
Connect the ET to the machine. See Illustration 1. After communication has been established, the ET
will list the electronic control modules that are on the machine.
320D Excavator BZP00001-UP (MACHINE) POWERED BY C6.4 Engine(SEBP5228 - ... Page 2 of 6
Illustration 1 g01211395
Location of the ET Connector
(1) ET Connector
Note: The ECM must detect specific set-up conditions before beginning the calibration procedure. If a
set-up step is not met, the calibration procedure is aborted.
Illustration 2 g01211396
Typical screen for accessing calibrations
The following is a list of all possible calibrations from the "Calibrations" drop-down menu. The
specific calibrations will differ across sales models.
4. From the "Calibrations" drop-down menu, select the desired calibration procedure.
Note: Additional screens will be displayed to notify the operator of the status of the calibration
procedure.
Illustration 3 g01161305
Note: Some calibration procedures require additional equipment.
320D Excavator BZP00001-UP (MACHINE) POWERED BY C6.4 Engine(SEBP5228 - ... Page 5 of 6
Illustration 4 g01161463
Typical screen for performing calibrations with multiple selections
320D Excavator BZP00001-UP (MACHINE) POWERED BY C6.4 Engine(SEBP5228 - ... Page 6 of 6
Illustration 5 g01211469
Typical screen for performing calibrations