LUBRIZOL® 9990A Farm Tractor Additive: Product - Type
LUBRIZOL® 9990A Farm Tractor Additive: Product - Type
LUBRIZOL® 9990A Farm Tractor Additive: Product - Type
Case New Holland CNH MAT3525 Case New Holland CNH MAT3509 Case New Holland CNH MAT3505
John Deere JDM J20D Kubota UDT Fluid Massey Ferguson CMS M1145
Massey Ferguson CMS M1143 Massey Ferguson CMS M1141 Massey Ferguson CMS M1135
ZF TE-ML 21F
Valtra G2-08, ZF TE-ML 06E and ZF TE-ML 06F are all formulation specific approvals.
VCE WB102 is formulation specific requiring 7% wt. LUBRIZOL® 9990A and testing and approval by
Volvo Construction Equipment
Physical Characteristics
Minimum Target Maximum
FLASH POINT, C, PMCC 115
Chemical Characteristics
Minimum % Weight Typical Maximum % Weight
BORON 0.140 0.170 0.200
NITROGEN 0.090
SULFUR 4.8
General handling instructions - In general, The Lubrizol Corporation recommends, as a minimum, the use of neoprene or
nitrile rubber gloves and safety glasses or chemical splash goggles. The Material Safety Data Sheet should be consulted for
specific information and for information on health and safety when handling this product
Fire and explosion hazard data
Flash Point (method) Classification
115oC PMCC N/A
Temperature recommendations
Unloading Pumping Temperature 25oC 77oF
Maximum temperature 70oC 158oF
Storage
Maximum temperature for long-term storage 45oC 113oF
Blending
Maximum base oil temperature for mechanical or in-line mixing 70oC 158oF
Equipment recommendations
Type of Pump Positive Displacement
Ball Launched, Insulated,Steam Traced Using 107°C/225°F Steam
Type of transfer line
Max.
Transfer line size 2-3inch/5-8 cm.
Heat source
Type Steam 107°C/225°F Max.
Storage tank Suction Heater Recommended
Viscosity data cSt SUS
at 25°C,77°F 690 3193
at 40°C, 104°F 250 1158
at 100°C, 212°F 20 98
Notes
Pour Point -30°C,-22°F
Additional Recommendations
* Holding the material in excess of this temperature may cause chemical degradation. Use steam for heating and tracing only
when the material is in motion to avoid localized overheating. Cold Temperature Storage - If product has been stored below
its pour point temperature it should be heated to 21°C/70°F before using.
Effective: 3/17/2016 7:34:10 AM