Specification For Spring SP Primary Supports: 0 16.06.2020 First Issue NV US SVK
Specification For Spring SP Primary Supports: 0 16.06.2020 First Issue NV US SVK
Specification For Spring SP Primary Supports: 0 16.06.2020 First Issue NV US SVK
TABLE OF CONTENTS
1.0 SCOPE.......................................................................................................................................................2
Page 2 of 3
Title: Specification for Spring
2.1 SPRING HANGER SUPPLIER.......................................................................................................................2
4 2
6 ASSEMBLIES................................................................................................................................................2
6.1 DATA SHEETS AND DRAWINGS................................................................................................................2
6.2 INSPECTION AND TESTING.......................................................................................................................3
8 PROTECTIVE COATING................................................................................................................................3
1.0 SCOPE
4
4.2 The cold setting and hot setting shall be identified by permanently attached white and red markers
respectively.
6 ASSEMBLIES
The required hanger assemblies shall be detailed on data sheets included in commodity
specification.
6.3 Weld sizes are to be shown on the assembly drawing by the vendor.
6.4 The vendor shall also provide outline drawings showing dimensioned mounting requirements for spring
hanger assemblies.
8 PROTECTIVE COATING
All hardware and assembly shall be painted with min. 2 coats of synthetic enamel unless otherwise specified.
Spring coil shall
10.1.1 Travel stops are to be removed and placed into their storage position after completion of the hydrostatic
testing, realignment of the piping connected to rotating machinery, and the installation of insulation.