Bipolar RF Ultrasonic Liposuction Cavitation

Vacuum Laser Slimming Machine

Theory
With collective strong sound wave head, strong sound wave of 40KHz maybe emitted to vibrate
fat cells at top speed and produce numerous vacuum air pockets inside and outside the fat cells,
robustly impact fat cells to generate introverted blast and disintegrate triglyceride into glycerol
and free fatty acids. Then RF waves at frequency of 1MHZ is used for exhausting the integrated
glycerol and free fatty acids through hepatoenteral circulation. Finally, vacuum RF and energy
electrode are used for positioning and tightening fat. In physics, it is known as "cavitation".
Microspore introverted blast inside and outside cell may lead to enhanced molecular motion and
a higher energy level and this will finally cause fat cell rupture and thereby achieve the effects of
body building and losing weight.

1. Dissolve fat, lymphatic drainage, firm skin and enhance skin elasticity
Negative pressure RF liposuction head Being integrated with the most advanced RF technology
and radio frequency, the Instrument may directly reach the deep-seated fat body and have the
excellence of targeted positioning RF. In the fast-active state, fat cell tissue may generate friction
heat, increase local temperature and remove excess fat and toxin from the body through sweat
gland, enterohepatic circulation and lymph and ultimately achieve the effect of dissolving fat.
With controlled depth technology, inlaid diamond particles of different sizes may rub skin along
its pattern, adjust suction strength by means of vacuum draw and rub with negative pressure
strong force to directly explode thick fat. Thus, the effects are very obvious: Enhance blood
circulation, accelerate the decomposition of fat, take away wastes, enhance the effect of
removing cellulite, effectively improve the state of areolar tissue, remove stubborn fat and
improve the sufficient absorption condition of diet products.

2. Strong force explosion fat and fat removal

Strong sound wave explosion fat head with collective strong sound wave head, strong sound
wave of 40KHz may be emitted to human body for impacting fat cells fiercely and causing friction
motion between fat cells. This may cause effective consumption of calories and moisture in fat
cells and reduce the size of fat cells. What's more, sound wave vibration may cause fierce impact
of fat cells to make them be exploded instantaneously, reduce the amount of fat cells and
thereby achieve the effects of removing fat.

3. Body Vacuum RF Probe

For body and face re-shaping. Weight loss Vacuum+RF slimming machine can promote tissue
metabolism, repel the cellulite, which make fat granule in different depths and shocking make
fusion energy, and the deepest receptor can get granule in 3cm thick of skin, and rapid expansion
and the rapid heating of the cell wall that exceed the elastic limits and arises cells broken, so that
the combustion of fatty acids at the same time broken out of a pot, not only the burning
consumption of fatty acids but also more directly emptying so rapidly reduce the size of granule.

4. Facial wrinkle elimination, tightening and lifting

Facial RF head A capacitive coupling electrode is used for transmitting radio-wave energy and
generating an electric field for entering into subcutaneous tissue through the skin surface. In the
high-frequency of 450 kHz, this electric field changes its polarity for 450,000 times per second.
To reply to the rapid change in electrode, directions of electrical particles the skin are also
changed. By this time, natural electric resistance in the subcutaneous tissue moves and generates
heat energy. As the papillary dermis collagen may immediately shrink when the temperature is
within the range from 60 to 70 Celsius degree, after wrinkle treatment, client may immediately
sense the skin tightening effects as it is being lifted and firmed. When collagen is produced
continuously, thickness and density of the skin papillary dermis may be increased to remove
wrinkles, eliminate scars, restore skin elasticity and gloss and make it be blonde and smooth.
While collagen is increased, fresh skin is generated in the position of operation and wrinkles are
removed by large amount of cells. In addition, when cortex without elasticity or that with thick
horny layer in the area with wrinkles is separated, surrounding skin will also be renewed.

5. Laser slimming
Laser Lipolysis is growing in popularity as a procedure for the tummy, arms, male breasts, hips
and outer thighs as well as smaller areas of the body such as redefining the jaw line, neck and
chin area. It carries fewer risks as traditional liposuction and is a less invasive surgical procedure
requiring fewer incisions and resulting in less scarring. We use laser liposuction after liquid
liposuction to tighten the skin.

Features & Functions

Features
1. The entire process is completed without the need of surgery and anesthesia.
2. Does not cause the phenomenon of uneven skin.
3. Does not cause the phenomenon of bleeding, swelling and blood stasis.
4. Without side effects and the risk of gaining the weight back, the results are rather obvious.
5. Non-invasive treatment does not affect the normal work and life.

Functions
Firm the arms, legs, thighs, buttocks, waist, back, abdominal muscles and reshape the body
figure *Improve and treat the orange peel like fatty tissues of different serious levels With the
effects of soothing, decompression and pain relief (such as joint pain, sciatica),promote the
regular mechanical aerobic exercise of skin tissue, rapidly relieve stress and remove fatigue.
Firm, lift and compact the skin and mould the face shape Circulate and activate cells, promote
metabolism and so that 100% more collagen and elastic fibers may be gained for improving the
facial and body skin

Package Including

Laser pads: 6 big +2 small

Multipolar RF handpiece (Tripolar RF)*1
40KHz Cavitation Handpiece*1
Vacuum Biploar Handpiece*1
Bipolar RF Handpiece for face*2
Power cord*1

Operation procedures

Vacuum RF liposuction head

Adjust the SUCK Energy level, and the PUT Energy level, (normally Suck energy should more
than the Put energy)
Adjust the RF level from 0 to 1,or 2….(you can try on our palm )

Notes:
1. Wipe the slimming essential oil on the skin and do massage before start the treatment.
2. Do not use the slimming gel for the smoothly, because the gel is easy block the vacuum head, it
is better to use the slimming essential oil.
3. Do not put so much slimming oil on the skin by each time. Pay attention to prevent the oil
sucked into the vacuum head, or it will damage the head
4. Adjust the intensity from low level to high level. Or try the head on hand in advance.
5. Turn off the instrument probe when it is not in use.

40KHz Ultrasonic Head:

Press "TIME SET" to adjust the time, select the strength of "LOW" , "MIDDLE" or "HIGH" by
clicking "-" to decrease the strength or click "+" to increase it. Press "PAUSE" to start the strong
Mode a.b.c.d means that:
"A" is continuous working for 3 sec and discontinuous for 2 sec.
"B" is continuous working for 4 sec and discontinuous for 3sec.
"C" is continuous working for 1 sec and discontinuous for 1 sec.
"D" is continuous working for 0.5 sec and discontinuous for 0.5sec.

Body RF head
Panel: Press "RF CHANNEL" in the display screen to select body RF output, select the suitable
intensity (adjust according to the customer's acceptable level, 3-6 is ok.), and at last press PAUSE
key. The face RF starts to work.

Tips: use some slimming essential oil on the skin for massage, then use the RF head to burn the
fat. move the head on the skin and do the massage.

Facial RF head
Press "TIME SET" to adjust the time,
Press "RF ENERGY" and then "+" to increase the RF intensity or "-" to decrease RF intensity.
Adjust to a proper level (according to acceptability of clients. General y speaking, levels 3 – 6 are
OK).Spread gel or wrinkle smoothing essence on the treated positions for hairdressing (general y
20-30G each time), operate with the facial RF head for 15-20 minutes with mainly the spiral
movement on face.

Laser pads
Operation Steps
1. You will have 6 large Diode Laser paddles placed on the targeted fatty areas and secured with
straps.
2. Then 2 smaller Diode Lasers will be placed over the appropriate lymphatic glands and held in
place.
3. The Laser Lipo BCS will then be switched on for 10 minutes, re-located and turned on for
another 10 minutes, this will be repeated one more time.
4. The treated area will now be re-measured to assess the inch-loss achieved. You can expect to
see a reduction of between 0.5 and 3 inches.(1.25 and 8cm’s).
Operation Guides

THIGH
Treated time: 30 minutes
1. From down to upper, pushing to the groin to dredge the lymph.
2. From down to upper, circling push by anticlockwise, can help decomposing fatness.
3. Also can push by come-and-go to decompose fatness.
4. Pull from the knee and muscle texture to upper, can improve the curve.
Treated time: 20 to 30 minutes
1. Along the lymph direction, pulling to the waist.
2. From upper to down, by anticlockwise gesture, pull come-and-go.
3. Along the muscle of arm, pull up to lift and tight the muscle.

BACK
Treated time: 20 to 30 minutes
1. First by come-and-go, pushing the bladder nerve 2 to 3 times.
2. Circling by anticlockwise to stimulate the underarm lymph node.
3. On the back, by anticlockwise circling, can help to decompose the fatness.
4. Using lymph drainage gesture, pull the toxin to the lymph node, can help improving the back
curve.

ARM
Treated time:30 minutes
BACK SIDE
1. From the inner elbow to the armpit, doing lymph drainage.
2. Circling to stimulate the lymph node.
3. By anticlockwise or come-and-go pushing, decomposing the fatness.
4. From the elbow to the oxter, doing tightening gesture.

Facade
1. from the elbow to the oxter, doing tightening gesture.
Abdomen
Treated time: 20 to 30 minutes
1. From small to large, by clockwise direction, circling around the navel, can help peristalsis of the
large intestine.
2. From small to large, by anticlockwise direction, circling push down.
3. From the belly and muscle texture, pull to the groin.
4. Through lymph drainage gesture, taking the toxin to the place of groin.

Notice:
Those do not use the machine:
1. Pregnant women or women during in menses.
2. Epileptic
3. Patients with malignancy.
4. Patient whose wound after operation has not healed up.
5. Acute inflammation or epidemical patients.
6. Whom with heart diseases or with heart pacemaker...
7. Whom with kidney (gall-stone) disease
8. Who was embedded metal object or silica gel
9. Who in menses, birth control period, emiction incontinence period, or accepting the belly
operation.
10. Whose body always take much inner hot.
11. Who has the genetic hypersensitivity.

Attention:
1. Be sure to use the Slimming essential oil
2. Avoid knocking the headpiece.
3.For avoiding burning the headpiece, during operation, please prepare enough ultrasonic gel.
4. Don't stay in one place, avoid treating on the bone.
5. Don't use disinfectant product to disinfect the use head. We suggest the wet cotton or dry towel
enough.
6. Check the machine power cord if it is connected well
7. If you don’t use the machine, please switch off it, and power off.
8. Please take off all metal decoration from the operator and patient’s body.
9. Please do not use the machine over 1 hour, after one hour, please turn off the machine and
cooling it
10. During the operation, be sure not to accept other treatment.

Tips:

*Important: It is necessary to drink about 2 liters of water per day, 2 or 3 days before the first
session, and after the treatment, should drink more water for detoxing… it helps for slimming.

*The lip cavitation-cons is indicated in the following cases:

Pregnant women, people with a pacemaker, defibrillator or metallic materials, on the scars of less
than 3 months
For people with diabetes and / or cardiovascular disease, among those who had previous
thrombosis or phlebitis
For persons on anticoagulant therapy, in patients with tumors or followed by a surgical procedure

*During any function treatment, the guests and beautician must take off all the metal jewelry, so
that can avoid appear the phenomenon of current increase.

Technical Parameters

Power supply Input: 110V/220V 60HZ/50HZ

Power: 500W
Laser pads:
Laser Type: Diode Laser
Laser Wave Length: 635-650nm
Maximum Output Power: 400W
Single Output: 50mW
Number Of Diode: 6*9+2*3=60 diode
40K cavitation head:
Power supply output: 150V
Frequency: 40 KHz
Power: 25W
Vacuum + Bipolar RF head:
Power supply output: 66V
Frequency: 450K
Power: 95W
Body RF head:
Power supply output: 66V
Frequency: 550k
Power: 50W
Tripolar RF head:
Power supply output: 66V
Frequency: 450K
Power: 35W

Face RF head:
Power supply output: 66V
Frequency: 450K
Power: 35W

SERVICE AND Warranty

Service
We will guarantee the quality of our equipment, normally there is no quality problem.
1. If there is a deficiency, please email or call us on the reasons, it would be best if this can be
dealt with by email or telephone. Cause some of the problems are caused by using the machine in
a wrong way.
2. We suggest the client to take photos of the area where the problem occurs, we will pass them to
our technician, and our technician will give a satisfactory answer within 1-7 working days

3. Warranty
From the date of purchasing according to the receipt.
Warranty for machine body:
1 year warranty for the machine body (not including the consumables hand pieces), if there have
any multifunction with the machine body, factory provide the circuit board or any other
accessories freely, customer bare shipping charge.

Warranty for the Handpieces:

3 months warranty for the hand pieces, if there have any malfunction with the hand pieces, factory
provide the hand pieces freely, customer bare the shipping charge.

Any other non-warranty parts or out of warranty period, can also be responsible for the
maintenance and updating, such as Spare parts and consumables cost, if need purchase, please
contact your dealer.

2, the following users’ personal reasons caused by the fault, do not provide free warranty service:
a. Malfunctions caused by abused operation
b. Malfunctions caused by modification or repair by anyone or not authorized by our company; or
the original serial number tag or product identification markings have been altered or removed
c. Malfunctions caused by other artificial factors like move or tear down in proper motion, or
collision, etc.
d. Malfunction caused by uncontrollable natural force
e. Energy reduce caused by wet environment and dust
f. Consumable parts of the equipment: handpieces
3, the company's product design specifications are subject to change without notice, if in doubt,
please contact the company

Voltage: 110V/220V 50-60Hz Power:500W

G.W.:15kgs
Package:40*41*49cm