Installation Instructions: Outlet Box (2) Outlet Box Screws (Not Supplied) Crossbar Backplate (2) Mounting Balls
Installation Instructions: Outlet Box (2) Outlet Box Screws (Not Supplied) Crossbar Backplate (2) Mounting Balls
Installation Instructions: Outlet Box (2) Outlet Box Screws (Not Supplied) Crossbar Backplate (2) Mounting Balls
1.Before beginning the installation, carefully unpack and identify all parts, referring
to the illustration.
CROSSBAR (2) OUTLET BOX SCREWS BACKPLATE
OUTLET BOX (not supplied) 2.Turn the electrical power to installation point OFF at the circuit breaker.
(2)MOUNTING
BALLS 3.Slip down the GLASS PANEL to the inside of the CAGE. Locate the TABS onto
the top edge of the GLASS PANEL and match the holes on them with the
MOUNTING HOLES on the top edge of the CAGE. Use screw driver, thread the
SCREWS into the MOUNTING HOLES and hand tighten until snug to secure the
GLASS PANEL.
(2) MOUNTING SCREWS 4.Lift the CAGE with the GLASS PANELS upward and align the holes on top
edge of CAGE with mounting holes on the bottom edge of the FIXTURE
FIXTURE SUPPLY WIRE HOOD. Secure them together by threading the LOCK SCREWS onto the
and GROUND WIRE mounting holes on the FIXTURE HOOD. Hand tighten until snug.
FIXTURE HOOD
SOCKET BASE
5.Place the CROSSBAR on the BACKPLATE and align the holes in the BACKPLATE
with a set of threaded holes in the CROSSBAR. Install the (2) MOUNTING
LAMP SCREWS in the aligned threaded holes on the CROSSBAR. Next, mount the
SCREW CROSSBAR to the outlet box with (2)OUTLET BOX SCREWS(not provided).
8.Install the Lamp into the Socket Base by aligning the pins on the Lamp with the
LOCK SCREW keyholes in the Socket Base. Once they are aligned, gently push the Lamp into
the keyholes and twist the Lamp to lock it in place.
1.( Refer to FIGURE2) For assemble the MOUNTING BALLS, please note that you are
required to apply a small amount of Silicone sealer to the threaded side of the
MOUNTING BALLS and then install them onto the MOUNTING SCREWS.
2. (Refer to FIGURE1) With the OUTDOOR FIXTURE properly installed in accordance with
FIGURE1 EXTERIOR GRADE supplied Assembly/installation instructions, proceed with caulking instructions below.
CAULK
Note: Be sure EXTERIOR WALL SURFACE and FIXTURE BACKPLATE are free to dirt to
caulking. Using EXTERIOR GRADE CAULK, start on one side of FIXTURE BACKPLATE and
follow contour, were the FIXTURE BACKPLATE meets the EXTERIOR WALL SURFACE
upward. Proceed to caulk over top of backplate and down other side. DO NOT CAULK
BOTTOM OF FIXTURE BACKPLATE to ensure proper moisture drainage.
FIGURE2
EXTERIOR GRADE
CAULK
OUTDOOR
FIXTURE BACKPLATE
MOUNTING BALL
IS-HCE8409FL
Page 2 of 2
Revised 2008-02-14