RTL - SDR DIY KITs Installation Instructions
RTL - SDR DIY KITs Installation Instructions
RTL - SDR DIY KITs Installation Instructions
com
V2.01
Note the installation instructions apply only provided by the shop KITs.
The note is not applicable to pirated KITs.
BA5SBA
ba5sba@163.com
ba5sba@163.com
1; check the kits plastic bag all parts contrast images, attention to keep
good in a small ferrite bead, don't lose it.
2;
ba5sba@163.com
Note that, on the back of the SMA interface also to welding, fixed pin
USB interface to welding firm
ba5sba@163.com
4; welding jumper and LED. Note, the long foot is LED positive.
A
through the power output of the 5V to the antenna interface, power supply
in active antenna amplifier. The default connection to
P .
Pin bending direction of LED refer to the above picture, careful not to
mistake or LED not bright.
ba5sba@163.com
5;
Note that the polarity of the capacitor refer to the above picture check.
After welding, cut off the excess part, take good care of cut pins, later
need to use.
ba5sba@163.com
Note that the polarity of the capacitor refer to the above picture check.
6;
ba5sba@163.com
Finishing a good
ba5sba@163.com
Envelope with paint in the 3mm drill bit, around 11 turns. Cut off excess.
ba5sba@163.com
7;
ba5sba@163.com
On the magnetic ring to wear around 9 turns with tricolor enameled wire.
Cut off the excess, take good care of the excess part, will also use.
The color of enameled wire to separate, pay attention to the head and tail
to be separated into different sides
ba5sba@163.com
The tail section of the yellow line head and red lines are connected
together.
ba5sba@163.com
ba5sba@163.com
decomposition
ba5sba@163.com
The circuit board is removed to the circuit board is embedded into the kits
of the.
ba5sba@163.com
Reliable welding solder red circles part. Note do not leak welding red
arrow part
ba5sba@163.com
ba5sba@163.com
10;
cut two 1 inch with the rest of the three color enameled wire, and
ba5sba@163.com
ba5sba@163.com
ba5sba@163.com
ba5sba@163.com
RTL-SDR.COM
THE BIG LIST OF RTL-SDR SUPPORTED SOFTWARE
http://www.rtl-sdr.com/big-list-rtl-sdr-supported-software/
Antenna Long Wire con Balun 9:1
http://www.radioamatoripeligni.it/i6ibe/balun9a1/balun9a1.htm
Alternative Installation Procedure for RTL.SDR and HDSDR
http://www.hamradioscience.com/alternative-installation-procedure-for-rtl-sticks-and-hdsdr/
ba5sba@163.com
signal receiving HF band needs to meet the HF Antennas such as Long Wire, Random Wire, Dipole etc.. To have
a good effect need matching antenna.