|
1.
|
Development and test of single-bore $Cos \vartheta$ Nb$_3$Sn dipole models with cold iron yoke
/ Andreev, N (Fermilab) ; Ambrosio, G (Fermilab) ; Barzi, E (Fermilab) ; Carcagno, R (Fermilab) ; Chichili, D R (Fermilab) ; DiMarco, J (Fermilab) ; Feher, S (Fermilab) ; Imbasciati, L (Fermilab) ; Kashikhin, V V (Fermilab) ; Lamm, M (Fermilab) et al.
Two short Nb$_3$Sn dipole models based on a single-bore cos-theta coil with a cold iron yoke were fabricated and tested at Fermilab. This paper summarizes the details of magnet design and fabrication procedure, and reports the test results including quench performance and quench heater studies, and the magnetic measurements..
FERMILAB-CONF-01-380.-
2002 - 5 p.
- Published in : IEEE Trans. Appl. Supercond. 12 (2002) 332-336
Fulltext: PDF;
In : 17th International Conference on Magnet Technology, CERN, Geneva, Switzerland, 24 - 28 Sep 2001, pp.332-336
|
|
|
2.
|
Development and test of Nb$_3$Sn cos-theta dipoles based on PIT strands
/ Zlobin, A V (Fermilab) ; Ambrosio, G (Fermilab) ; Andreev, N (Fermilab) ; Barzi, E (Fermilab) ; Bossert, R (Fermilab) ; Carcagno, R (Fermilab) ; Chichili, D R (Fermilab) ; Elementi, L (Fermilab) ; Feher, S (Fermilab) ; Kashikhin, V V (Fermilab) et al.
Fermilab is involved in the development of new generation high-field accelerator magnets using state-of-the-art Nb$_3$Sn strands produced using different technologies. Two 1-m long models-mirror configuration and dipole magnet-were fabricated recently at Fermilab based on powder-in-tube (PIT) Nb$_3$Sn strands with small effective filament size. [...]
FERMILAB-CONF-04-274-TD.-
2005 - 4 p.
- Published in : IEEE Trans. Appl. Supercond. 15 (2005) 1160-1163
Fulltext: PDF; External link: Fermilab Library Server (fulltext available)
In : Applied Superconductivity Conference: Harnessing the Magic, Jacksonville, FL, USA, 3 - 8 Oct 2004, pp.1160-1163
|
|
|
3.
|
Test results of shell-type Nb$_3$Sn dipole coils
/ Feher, S (Fermilab) ; Ambrosio, G (Fermilab) ; Andreev, N (Fermilab) ; Barzi, E (Fermilab) ; Carcagno, R (Fermilab) ; Chichili, D R (Fermilab) ; Kashikhin, V (Fermilab) ; Kashikhin, V V (Fermilab) ; Lamm, M J (Fermilab) ; Orris, D (Fermilab) et al.
Several different shell type coils were made by using the 'wind-and-react' technique, installed in a mirror magnet configuration and tested at Fermilab. The results revealed that the previously suspect splice technique is adequate and is not responsible for the quench performance limitation. [...]
FERMILAB-FN-0864-TD.-
2004 - 4 p.
- Published in : IEEE Trans. Appl. Supercond. 14 (2004) 349-352
In : 18th International Conference on Magnet Technology, Morioka, Japan, 20 - 24 Oct 2003, pp.349-352
|
|
|
4.
|
First Field Measurements of the 15 T Nb$_3$Sn Dipole Demonstrator MDPCT1
/ Strauss, T (Fermilab) ; Barzi, E (Fermilab) ; DiMarco, J (Fermilab) ; Kashikhin, V V (Fermilab) ; Novitski, I (Fermilab) ; Tartaglia, M (Fermilab) ; Velev, G (Fermilab) ; Zlobin, A V (Fermilab)
Within the US Magnet Development Program (MDP) a 15 T Nb3Sn dipole was developed, to demonstrate a magnet design for a post-LHC pp Collider. The magnet design is based on 60 mm aperture 4-layer shell-type coils, graded between the inner and outer layers to maximize the magnet performance. [...]
FERMILAB-CONF-19-475-TD.-
2020 - 6 p.
- Published in : IEEE Trans. Appl. Supercond. 30 (2020) 4001106
Fulltext: PDF; External link: Fermilab Accepted Manuscript
In : 26th International Conference on Magnet Technology (MT-26), Vancouver, Canada, 22 - 27 Sep 2019, pp.4001106
|
|
|
5.
|
Test Results of 15 T Nb$_3$Sn Quadrupole Magnet HQ01 with a 120 mm Bore for the LHC Luminosity Upgrade
/ Caspi, S (LBL, Berkeley) ; Ambrosio, G (Fermilab) ; Anerella, M (Brookhaven) ; Barzi, E (Fermilab) ; Bingham, B (LBL, Berkeley) ; Bossert, R (Fermilab) ; Cheng, D W (LBL, Berkeley) ; Chlachidze, G (Fermilab) ; Dietderich, D R (LBL, Berkeley) ; Felice, H (LBL, Berkeley) et al.
In support of the luminosity upgrade of the Large Hadron Collider (LHC), the US LHC Accelerator Research Program (LARP) has been developing a 1-meter long, 120 mm bore Nb$_3$Sn IR quadrupole magnet (HQ). With a short sample gradient of 219 T/m at 1.9 K and a conductor peak field of 15 T, the magnet will operate under higher forces and stored-energy levels than that of any previous LARP magnet models. [...]
2010 - 4 p.
- Published in : IEEE Trans. Appl. Supercond. 21 (2010) 5623312
In : Applied Superconductivity Conference 2010, Washington, DC, USA, 1 - 6 Aug 2010, pp.1854-1857
|
|
|
6.
|
Development of a 15 T Nb$_3$Sn Accelerator Dipole Demonstrator at Fermilab
/ Novitski, I (Fermilab) ; Andreev, N (Fermilab) ; Barzi, E (Fermilab) ; Carmichael, J (Fermilab) ; Kashikhin, V V (Fermilab) ; Turrion, D (Fermilab) ; Yu, M (Fermilab) ; Zlobin, A V (Fermilab)
A 100-TeV-scale Hadron Collider (HC) with a nominal operation field of at least 15 T is being considered for the post-LHC era, which requires using the Nb$_3$Sn technology. Practical demonstration of this field level in an accelerator-quality magnet and substantial reduction of the magnet costs are important requirements for realization of such a machine. [...]
FERMILAB-CONF-15-442-TD.-
2016 - 7 p.
- Published in : IEEE Trans. Appl. Supercond. 26 (2016) 4001007
External link: Fermilab Accepted Manuscript
In : 24th International Conference on Magnet Technology, Seoul, Korea, 18 - 23 Oct 2015, pp.4001007
|
|
|
7.
|
Design Concept and Parameters of a 15 T Nb$_{3}$Sn Dipole Demonstrator for a 100 TEV Hadron Collider
/ Zlobin, A V (Fermilab) ; Andreev, N (Fermilab) ; Barzi, E (Fermilab) ; Kashikhin, V V (Fermilab) ; Novitski, I (Fermilab)
FNAL has started the development of a 15 T Nb$_{3}$Sn dipole demonstrator for a 100 TeV scale hadron collider. This paper describes the design concept and parameters of the 15 TNb$_{3}$Sn dipole demonstrator. [...]
FERMILAB-CONF-15-179-TD.-
2015 - 3 p.
- Published in : 10.18429/JACoW-IPAC2015-WEPTY041
Fulltext: PDF; External link: Full-text at JACoW Server
In : 6th International Particle Accelerator Conference, Richmond, VA, USA, 3 - 8 May 2015, pp.WEPTY041
|
|
|
8.
|
Field Quality Study of the LARP Nb$_3$Sn 3.7 m-Long Quadrupole Models of LQ series
/ Velev, G V (Fermilab) ; Ambrosio, G (Fermilab) ; Andreev, N (Fermilab) ; Anerella, M (Brookhaven Natl. Lab.) ; Bossert, R (Fermilab) ; Caspi, S (LBNL, Berkeley) ; Chlachidze, G (Fermilab) ; DiMarco, J (Fermilab) ; Escallier, J (Brookhaven Natl. Lab.) ; Felice, H (LBNL, Berkeley) et al.
After the successful test of the first long Nb$_3$Sn quadrupole magnet (LQS01), the US LHC Accelerator Research Program (LARP) has assembled and tested a new 3.7 m-long Nb$_3$Sn quadrupole (LQS02). This magnet has four new coils made of the same conductor as LQS01 coils, and it is using the same support structure. [...]
2012 - 4 p.
- Published in : IEEE Trans. Appl. Supercond. 22 (2012) 9002804
In : 22nd International Conference on Magnet Technology, Marseille, France, 12 - 16 Sep 2011, pp.9002804
|
|
|
9.
|
Test Results of the First 3.7 m long Nb$_3$Sn Quadrupole by LARP and Future Plans
/ LARP Collaboration
In December 2009 during its first cold test, LQS01, the first Long Nb$_3$Sn Quadrupole made by LARP (LHC Accelerator Research Program, a collaboration of BNL, FNAL, LBNL and SLAC), reached its target field gradient of 200 T/m. This target was set in 2005 by the US Department of Energy, CERN and LARP, as a significant milestone toward the development of Nb$_3$Sn quadrupoles for possible use in LHC luminosity upgrades. [...]
FERMILAB-PUB-10-312-TD.-
2010 - 5 p.
- Published in : IEEE Trans. Appl. Supercond. 21 (2010) 1858-1862
Fulltext: PDF; External link: FERMILABPUB
In : Applied Superconductivity Conference 2010, Washington, DC, USA, 1 - 6 Aug 2010, pp.1858-1862
|
|
|
10.
|
Field Quality of the First LARP Nb$_3$Sn 3.7m-Long Quadrupole Model of LQ Series
/ Velev, G V (Fermilab) ; Ambrosio, G (Fermilab) ; Andreev, N (Fermilab) ; Anerella, M (Brookhaven) ; Bossert, R (Fermilab) ; Caspi, S (LBL, Berkeley) ; Chlachidze, G (Fermilab) ; DiMarco, J (Fermilab) ; Escallier, J (Brookhaven) ; Felice, H (LBL, Berkeley) et al.
The US-LHC accelerator research program (LARP) built and tested the first 3.7-m long Nb$_3$Sn quadrupole model of LQ series with a 90 mm bore diameter and a target field gradient of 200 T/m. The LQ series, developed in collaboration among FNAL, LBNL and BNL, is a scale up of the previously tested 1-m long technology quadrupoles of TQ series based on similar coils and two different mechanical structures (shell-based TQS and collar-based TQC), with a primary goal of demonstrating the Nb$_3$Sn accelerator magnet technology for the luminosity upgrade of LHC interaction regions. [...]
FERMILAB-CONF-10-270-TD.-
2011 - 4 p.
- Published in : IEEE Trans. Appl. Supercond. 21 (2011) 1688-1691
Fulltext: PDF; External link: FERMILABCONF
In : Applied Superconductivity Conference 2010, Washington, DC, USA, 1 - 6 Aug 2010, pp.1688-1691
|
|