Petwant PWS 107 Stylish Pet Fountain Instruction Manual

Contents hide

1 Petwant PWS 107 Stylish Pet Fountain

2 Product Usage Instructions

7 Documents / Resources

7.1 References

8 Related Posts

Petwant PWS 107 Stylish Pet Fountain

Product Usage Instructions

Insert the pump into the foam filter and slide both into the round bowl.
Press them down so that the suction cups snap into place.

Insert the USB cable down into the hole in the holder and out through the notches on the bottom of the holder.
Replace the cable cap that holds the cable in place.

Align the outlet pipe with the water pump outlet and press it firmly.
Align the notch and install the filter tray. Gradually install the lid and T-tap.

Connect the power adapter. Place the fountain where your pet will use it.
Fill the bowl with water, leaving half an inch of space between the water and the rim.

Make sure your hands, the cord, and the power adapter are dry, then plug the fountain into a wall outlet.
Remove the pump cover.

Wash the filter with soap and warm water.
Remove the impeller and clean all parts with soap and warm water.

Soak the filter for 5 minutes in a clean container.
Remember to turn off and disconnect the power for safety reasons when the equipment is not in use.

The power adapter and the wired plug must not be soaked during cleaning.
This product must not be operated without water.

Disconnect the power supply before servicing and cleaning the machine.

Thank you for supporting us.
To ensure a continuous supply of fresh, clean water for your pet, read the instructions carefully. If you experience any problems, complaints, or support during use, please contact us in time to help you resolve the issue

Attention

Maintain the water level.
The pump is designed to operate in water depths of at least 2.5 cm

Clean it regularly, at least every 2 weeks.
Change the filter regularly.

Change the carbon filter every 4 weeks. Replace the foam filter every 2 months.

Detail

Installation

Install the foam filter and pump

Insert the pump into the foam filter and slide both into the round bowl. Press them down so that the suction cups snap into place.

Insert the USB cable down into the hole in the holder and out through the notches on the bottom of the holder. Replace the cable cap that holds the cable in place.

Align the outlet pipe with the water pump outlet and press it firmly.

Align the notch and install the filter tray.

Install the filter, lid, and accessories for the fountain

Soak the filter for 5 minutes in a clean container.

Gradually install the lid, and T-tap.

Connect the power adapter.

Place the fountain where your pet will use it. Fill the bowl with water, leaving half an inch of space between the water and the rim. Make sure your hands, the cord, and the power adapter are dry, then plug the fountain into a wall outlet.

Cleaning

Remove the pump cover
Wash the filter with soap and warm water

Remove the impeller and clean the parts with soap and warm water

Notice

Remember to turn off and disconnect the power for safety reasons when the equipment is not in use.
The power adapter and the wired plug must not be soaked during cleaning.
This product must not be operated without water.

Disconnect the power supply before servicing and cleaning the machine.

FAQ

Q: How often should I change the carbon filter?
- A: The carbon filter should be changed every 4 weeks.

Q: Can I operate the fountain without water?
- A: No, this product must not be operated without water to prevent damage to the pump.
Q: How frequently should I clean the fountain?
- A: It is recommended to clean the fountain at least every 2 weeks to maintain optimal performance.

The device has been approved for use in EU countries and is therefore CE-marked. All necessary documentation is available on the website: www.electric-collars.com Changes to technical parameters, features, and printing errors are subject to change.