Endon 102895 Cape Floor Light Instructions

These instructions are for your safety. Please read through them thoroughly before use and retain them for future reference. If you are in any doubt about installing this product, consult a qualified electrician.
This product is only suitable for connection to a 220-240V~ 50Hz supply. It is for indoor use only, and not suitable for a bathroom location.
This fitting is a Class II, Double Insulated product and does not require an Earth. Live or Neutral must not be connected to Earth.
Do not attempt to plug in or use this product until it has been fully assembled. Disconnect from mains during assembly or maintenance. this product must be used on a stable, flat surface.
Under no circumstances must this floor lamp be covered with any material as this could pose a safety hazard. This product is not suitable for persons under 14 years of age.
This product may contain delicate parts – be careful during handling and maintenance to avoid breakage.
The lamp must be protected by a 3 amp fuse in the mains plug.
Never fit bulbs of a higher wattage than those specified on the label as these may damage the fitting.
The lampshade part can be adjusted to an appropriate angle as needed.
Never put anything on the product or hang anything on any part of this product.
If the external flexible cable or cord of this luminaire is damaged, it must only be replaced by a qualified electrician to avoid any electrical hazards.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or local store for recycling advice.