MALMBERGS 2700490DK 4G Network Router
Introduction
The 4G router is an optional internet access device installed in the charger, which can provide a 4G network for the charger. If there is no local WiFi access point at the installation site, the 4G router could be an option.
Please follow the steps below to connect the charger to the 4G router.
4G Connection
- Insert a 4G SIM Card into the SIM card port at the edge of the 4G router.
Note: Please make sure your SIM card is valid and internet service active before installation.
- Connect your smartphone to the WiFi of the 4G router.
WiFi Name: WiFi-* * * * , (* * * * is the last 4 digits of the router MAC)
Password: 12345678
- Log in to the setting page of the 4G router.
Enter 192.168.10.1 (IP of the 4G router) in your smartphone browser:
User name: admin
Password: admin
- Router mode setting
STEP 1: Click “3G/4G” to set your SIM card “APN”, then apply it.
STEP 2: Click “Mode” in navigation bar.
STEP 3: Choose “3G/4G Wireless Router Mode” and apply.
The router will now reboot and switch to 4G mode.
If you find your smartphone connected to internet via the WiFi of 4G router, that means that the 4G router is already online. Follow the instructions in the AP manual to connect the WiFi to charger.
Ethernet Connection
If you connect the ethernet cable to the charger, please click H Mode” in navigation bar, then select H Standard Wireless Router Mode” and apply it. The router will now reboot and switch to standard mode. Please use your phone to check that the WiFi signal is strong, and follow the instructions in the AP manual to connect the WiFi to charger.
Customer Support
Malmbergs Elektriska AB, PO Box 144, SE-692 23 Kumla, SWEDEN
Phone: +46 19 58 77 00
info@malmbergs.com
www.malmbergs.com
Documents / Resources
| MALMBERGS 2700490DK 4G Network Router [pdf] Instruction Manual 2700490DK, 2700490DK 4G Network Router, 4G Network Router, Network Router, Router |