Longriver V2 Shower System
Wireless Water Temperature Monitor Manual
- Remove the hook plate from the back of the monitor, tear off the 3M adhesive tape, and stick it upwards in the direction of the hook plate arrow at a suitable visible height on the wall.
- Press the button on the back of the display screen to turn it on, then press it again to turn it off. When in the on state, the screen signal indicator light starts flashing, indicating that the display screen is already in the on state. When the faucet is turned on, the signal indicator light stays on, indicating that a temperature signal has been received and the water temperature is displayed.
- Insert the display screen into the hook plate from top to bottom.
- When the battery indicator light turns red, it indicates that the battery is low and needs to be charged. The battery indicator light shows blue, indicating that it is charging When the indicator light displays green, it means it is full.
Introduction to Display Screen Content
Sensor Installation Manual
- Remove the hose nut from the faucet outlet
- Screw the sensor into the faucet outlet
- After turning on the temperature display screen, turn on the faucet to show the current water temperature.
Attention: The inlet and outlet directions of the sensor, The connection is reversed and cannot function properly.
Declaración de exposición á radiación da FCC
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with h minimum distance of 20cm between the radiator & your body.
Aviso da FCC
Este dispositivo cumpre coa Parte 15 das normas da FCC.
O funcionamento está suxeito ás dúas condicións seguintes:
(1) Este dispositivo non pode causar interferencias prexudiciais,
(2) Este dispositivo debe aceptar calquera interferencia recibida, incluídas as que poidan causar un funcionamento non desexado.
NOTA 1
This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following. Measuress:
- Reorienta ou reubica a antena receptora.
- Aumentar a separación entre o equipo e o receptor.
- Conecte o equipo a unha toma dun circuíto diferente ao que está conectado o receptor.
- Consulte ao distribuidor ou a un técnico experimentado de radio/TV para obter axuda.
NOTA 2
Calquera cambio ou modificación desta unidade non aprobada expresamente pola parte responsable do cumprimento pode anular a autoridade do usuario para utilizar o equipo.
Documentos/Recursos
| Longriver V2 Shower System [pdf] Guía de instalación 2BMQM-MX01, 2BMQMMX01, mx01, V2 Shower System, V2, Shower System, System |