Library that enables .NET Micro Framework developers to use Nordic 2.4 GHz wireless tranceivers. This library can be used on any net mf device. It uses SPI to communicate with the module. Developers can send serial data (max 32 byte per packet) from one board to specified receiver address. Each board can have up to 6 addresses (receive packets sent to those addresses).
- Low cost (complete module costs aprox. 7 USD)
- Drop in compatible with the nRF24L01
- Worldwide 2.4GHz ISM band operation
- Up to 2 Mbps on-air data rate
- Ultra low power operation and advanced power management
- 11.3mA peak TX current at 0dB output power
- 13.5mA peak RX current at 2 Mbps air data rate
- 900nA in power down mode
- On chip voltage regulator, 1.9 to 3.6V supply range
- Enhanced ShockBurst™ hardware link layer
- Automatic packet assembly (Preamble, Address and CRC)
- Dynamic payload length
- Selective auto acknowledgment with payload
- Auto retransmit
- 6 data pipe MultiCeiver™
- Fully air compatible with Nordic nRF2401A, 02, E1 and E2 at 1 Mbps and 250 kbps air data rates
- Low cost external ±60ppm 16MHz crystal
- 5V tolerant inputs
- Low cost chip inductors
- Compact 20-pin 4x4mm QFN package