Releases have the following items:

• duckGO -- these are the scripts and files for generate the inject.bin.
• firmware -- these are the codes of the firmware and compiled .bin file.
• fwburner -- these are the .bin files of the pendrive burner image.
• restore -- these are the binaries of all tools for restore the pendrive.
• tools -- these are the compiled binaries of all the tools.

Take note that the firmware patches have only been tested against PS2251-03 firmware version 1.03.53 (which is for an 8K eD3 NAND flash chip). They may work for others, but be careful.

As long as you are using the correct firmware image for your controller version and NAND chip, there is no harm in downgrading to an earlier version (such as from 1.10.53).

WARNING: This is experimental software. Use on unsupported devices, or even on supported devices, may cause loss of data, or even permananent damage to devices. Use at your own risk.

See Known Supported Devices for information on supported devices; use on an unsupported device may cause permanent damage to the device.

Run DriveCom, passing in the drive letter representing the drive you want to flash, the path of the burner image you obtained, and the destination path for the firmware image:

tools\DriveCom.exe /drive=E /action=DumpFirmware /burner=BN03V104M.BIN /firmware=firmware.bin

where BN03V104M.BIN is the path to the burner image, and firmware.bin is the resulting firmware dump.

Run DriveCom, passing in the drive letter representing the drive you want to flash, the path of the burner image you obtained, and the path of the firmware image you want to flash:

tools\DriveCom.exe /drive=E /action=SendFirmware /burner=BN03V104M.BIN /firmware=firmware.bin