JMP (x86 instruction)

This article has multiple issues. Please help improve it or discuss these issues on the talk page. (Learn how and when to remove these messages) This article needs to be updated. Please help update this article to reflect recent events or newly available information. (February 2017) The topic of this article may not meet Wikipedia's general notability guideline. Please help to demonstrate the notability of the topic by citing reliable secondary sources that are independent of the topic and provide significant coverage of it beyond a mere trivial mention. If notability cannot be shown, the article is likely to be merged, redirected, or deleted. Find sources: "JMP" x86 instruction – news · newspapers · books · scholar · JSTOR (September 2022) (Learn how and when to remove this message) (Learn how and when to remove this message)

In the x86 assembly language, the JMP instruction performs an unconditional jump. Such an instruction transfers the flow of execution by changing the program counter. There are a number of different opcodes that perform a jump; depending on whether the processor is in real mode or protected mode, and an override instruction is used, the instructions may take 16-bit, 32-bit, or segment:offset pointers.^[1]

Look up relative or absolute in Wiktionary, the free dictionary.

There are many different forms of jumps: relative, conditional, absolute and register-indirect jumps.

The following examples illustrate:

1. a relative jump with a 16-bit pointer;
2. a long jump (inter-segment), a relative jump with a 32-bit pointer;
3. and a register-indirect absolute jump using the EAX register.

(Note that although the first and second jumps are relative, commonly the destination address is shown instead of the relative offset as encoded in the opcode.)

Example one: Load IP with the new value 0x89AB, then load CS with 0xACDC and IP with 0x5578.

JMP 0x89AB
JMP 0xACDC:0x5578

Example two: Load EIP with the value 0x56789AB1, only in protected mode or unreal mode.

JMP 0x56789AB1

Example three: Jump to the value stored in the EAX register, only in protected mode.

JMP EAX

• Using SHORT (Two-byte) Relative Jump Instructions