Three-Phase Inverters Open-Circuit Fault Diagnostic Based on Voltage Residual
Authors: 
Yan Ke, Bo Fan, Tianlin NiuAuthors Info & Claims
Article No.: 46, Pages 1 - 5
Abstract
Aiming at the open circuit fault diagnosis of three-phase inverters, a fault diagnosis method based on residual theory with dynamic reference quantity is proposed. Using the existing phase voltage sampling signal of the inverter closed-loop control system, the phase voltage sampling signal with one period delay is used as a dynamic reference, and the voltage residual waveform is obtained by comparing the dynamic reference voltage signal with the current phase voltage signal. By setting a reasonable fault detection threshold, the voltage residual waveform can be used to accurately diagnose the open circuit fault of the inverters. Simulation results show that this method has the ability to resist unbalanced load and load mutation interference, and the diagnosis time is less than one fundamental wave cycle.
References
[1]
Fuchs F W. Some Diagnosis Methods for Voltage Source Inverters In Variable Speed Drives with Induction Machines A Survey[C]// Conference of the IEEE Industrial Electronics Society. IEEE, 2003.
[2]
O. V. Thorsen and M. Dalva, "A survey of the reliability with an analysis of faults on the variable frequency drives in industry," in Proc. Conf. Rec.6th Eur. Power Electron. Appl. Conf., Sevilla, Spain, 1995, pp. 1033--1038.
[3]
H. Schwab, A. Klonne, S. Reck, and I. Ramesohl, "Reliability evaluation of a permanent magnet synchronous motor drive for an automotive application," in Proc. Conf. Rec. 10th Eur. Power Electron. Appl. Conf., Toulouse, France, 2003, ISBN: 90--75815-07-7.
[4]
Lu B, Sharma S K. A Literature Review of IGBT Fault Diagnostic and Protection Methods for Power Inverters[J]. IEEE Transactions on Industry Applications, 2009, 45(5): 1770--1777.
[5]
Kim M S, Park B G, Kim R Y, et al. A novel fault detection circuit for short-circuit faults of IGBT[C]// Applied Power Electronics Conference and Exposition (APEC), 2011 Twenty-Sixth Annual IEEE. IEEE, 2011.
[6]
Huang F, Flett F. IGBT Fault Protection Based on di/dt Feedback Control[C]//Power Electronics Specialists Conference, 2007. PESC 2007. IEEE. IEEE, 2007.
[7]
Rodriguez-Blanco M A, Claudio-Sanchez A, Theilliol D, et al. A Failure Detection Strategy for IGBT Based on Gate-Voltage Behavior Applied to a Motor Drive System[J]. IEEE Transactions on Industrial Electronics, 2011, 58(5): 1625--1633.
[8]
D. Kastha and B. K. Bose, "Investigation of fault modes of voltage-fed inverter system for induction motor drive," IEEE Trans. Ind. Appl., vol. 30, no. 4, pp. 1028--1038, Jul./Aug. 1994.
[9]
R. Peuget, S. Courtine, and J. P. Rognon, "Fault detection and isolation on a PWM inverter by knowledge-based model," IEEE Trans. Ind. Appl., vol. 34, no. 6, pp. 1318--1326, Nov./Dec. 1998.
[10]
K. Rothenhagen and F. W. Fuchs, "Performance of diagnosis methods for IGBT open circuit faults in three phase voltage source inverters for ac variable speed drives," in Proc. Eur. Power Electro. Appl. Conf., 2005, pp. 1--10.
[11]
F. Charfi, F. Sellami, and K. Al-Haddad, "Fault diagnosis in power system using wavelet transforms and neural networks," in Proc. IEEE Int. Symp. Ind. Electron., 2006, pp. 1143--1148.
Recommendations
A novel IGBT open-circuit protection method for three-phase PWM rectifier
In order to avoid the damage or the secondary fault caused by serious over-current, a new solution for protection of IGBT open-circuit faults in three-phase PWM rectifier is presented in this paper. Firstly, the open-circuit faults features of three-phase ...
Catastrophic Bifurcation in Three-Phase Voltage-Source Converters
IWCFTA '11: Proceedings of the 2011 Fourth International Workshop on Chaos-Fractals Theories and ApplicationsActive pulse-width-modulated (PWM) voltage rectifiers are commonly used to convert ac power from a three-phase grid to a regulated dc voltage with unity input power factor. The output voltage regulation is normally achieved by an outer voltage feedback ...
Low-Voltage CMOS Transconductor-C Filter Design Using Charge-Pump Circuit
A very low voltage transconductor for video frequency range applications and compatible with standard CMOS technology is described. In the proposed transconductor, except the DC level shifter circuit (DCLS), the whole transconductor uses the main supply ...
Comments
Please enable JavaScript to view thecomments powered by Disqus.Information & Contributors
Information
Published In
December 2019
870 pages
ISBN:9781450372930
DOI:10.1145/3386415
Copyright © 2019 ACM.
Permission to make digital or hard copies of all or part of this work for personal or classroom use is granted without fee provided that copies are not made or distributed for profit or commercial advantage and that copies bear this notice and the full citation on the first page. Copyrights for components of this work owned by others than the author(s) must be honored. Abstracting with credit is permitted. To copy otherwise, or republish, to post on servers or to redistribute to lists, requires prior specific permission and/or a fee. Request permissions from [email protected].
Publisher
Association for Computing Machinery
New York, NY, United States
Publication History
Published: 30 May 2020
Check for updates
Author Tags
Qualifiers
- Short-paper
- Research
- Refereed limited
Conference
ICITEE-2019
ICITEE-2019: 2nd International Conference on Information Technologies and Electrical Engineering
December 6 - 7, 2019
Hunan, Zhuzhou, China
Contributors
Other Metrics
Bibliometrics & Citations
Bibliometrics
Article Metrics
- 0Total Citations
- 25Total Downloads
- Downloads (Last 12 months)1
- Downloads (Last 6 weeks)0
Reflects downloads up to 16 Nov 2024
Other Metrics
Citations
View Options
Login options
Check if you have access through your login credentials or your institution to get full access on this article.
Sign in