Welding lead holder

The "Tower of Power" Welding Cart Project

Description: I made these to fit an empty space on my service truck. There is a manual outrigger in between the service body and the welder deck.They pull out when you want to use them and roll up and push in to store them. They are right next to my welder, I just hook up a small set of jumper leads from the quick connects on these reels to the quick connects on my welder. Build Process: They are made out of 1/4" plates for the main spool supports and 3" box tubing to fit over the outrigger…

Bigweld Johnny Ray’s Instagram photo: “Welding rod holder”

Decided to make a torch holder for the welding table. Design requirement was for it to accommodate both the stick holder and the flux core wire holder. Cut some lengths of 1/8" x 1" bar stock. Purchased the 95 lb. magnet from Harbor Freight. Pre-weld setup using vise-grip and magnets. You can see my torch holder draped over the vise-grip... which illustrates problem. Cut a 3" length of PVC conduit and cut out a section that fits the stick holder. The width of the cut fits on either side of…

William Nguyen on Instagram: "#TIG #welding bar rest with a pony vise #tipsandtricks #weld #welder"

Homemade welding reels, first attempt