Workbench Assembly Instructions
Workbench Assembly Instructions
Workbench Assembly Instructions
MC2004/ MC2005
Items Included:
4- SLOTTED LEGS
4- PUNCHED LONG SUPPORT BEAMS
4- PUNCHED SHORT SUPPORT BEAMS
1- 9mm THICK
Items WOODEN
needed SHELF* bench:
to complete
1
1- piece
15MM
1 piece (wood
THICK
wood or metal)
WOODEN
(1/2", for shelf
3/4", orWORKTOP*
1") for shelf.
1 piece (wood or metal) for worktop (Workbench shown here with
*1 PLEASE
pieceNOTE
wood (1/2", 3/4",
WORKTOPS orINCLUDED
ARE NOT 1") for worktop.
IN ALL KITS wood shelf and wood top in place.
Wood
(wood or
notmetal may be used but
included)
are NOT included)
ASSEMBLY
6. The
shelf
5.The worktop and self can
can 5 6
bench can
now be fitted. They can be
now be
fixed in place using a nut and
fixed to the
bolt (not supplied) to the pre-
ground
drilled support beams and the
using the
top corners of the legs.
bottom
location
holes.
www.metalcraftusa.com
Suggested Table Layouts
Suggested layouts for Practical
for mounting and
Metalcraft Master packages
workshop Tool Setsfor
MC2004
(Please note: the place where you choose to locate your bench may have an influence over these layouts)
Please note
Note
Beware—the place where you choose to locate your bench may have an influence over these layouts.
Note
1. Tool Set Practical V2 shown in photo 1. 2. Tool Set Master V3 shown in photo 2.
Use similar layout for the Tool Set Practical V1. Use similar layout for Master Tool Sets V1 and V2.
1. MC005—Practical Pro Workshop. Use a similar layout for the
Practical set MC003
Please note and
the mini the Practical
bench pedestal Lite set MC002
shown is NOT Please note the Basket Attachment for the
included with the benches or with tool set packages. Master Twister shown is a tool set option
Please note that the new Mini Bench Pedestal (MC2003) shown and2.NOT included
MC004X withWorkshop
–Master the benches.
plus MC027
is not included with the benches or with the workshop packages. – Master Twister
1 2
Photo 1 Photo 2
Floor protectors shown are not included Floor protectors shown are not included
SAFETY ADVICE.
When operating Metalcraft Tools there can be quite high forces applied by the
levers which can have the effect of making the workbenches slide on the surface
of your floor. This naturally depends on the type of surface you choose to place
your bench on. If you would like to prevent the bench from moving, you can either
place plenty of ballast weight approx. 80kg or simply bolt down the workbench
(175 lbs. min)
www.metalcraftusa.com