Polyworks Cybermapping - 2009 Building A Mesh From Text Files
Polyworks Cybermapping - 2009 Building A Mesh From Text Files
Polyworks Cybermapping - 2009 Building A Mesh From Text Files
2- Click update
then zoom to the
outcrop to see
3- Click OK the changes
when you finish
Focus distance
A text box that specifies a distance from the scan origin.
This distance is used for two purposes. At focus distance it
identifies a circular zone of data
points in the middle of the first range. Its value is then
doubled to calculate the upper limit of the first range. Note
that each time a value is specified, the Step at focus value
is automatically calculated.
Step at focus
A text box that specifies the point-to-point spacing
calculated by IMAlign at the Focus distance. Since it is
calculated in the middle of the first range, it provides a good
average interpolation step for that range. Its value is
doubled for each subsequent range, and used as the
interpolation step for the range when it is larger than the
Min. interpolation step. You may also enter your own
base value in the text box.
Max edge length
A text box that specifies the base value used to limit the maximum triangle edge
length for each range. The default value is 1000. It is recommended to change this
value. This value is used for the first range and doubled for each subsequent range.
Note that to see the bridging in the 3D rendering window, the drawing type of the
Static display mode should be set to Flat (View > Image Default Static > Flat).
Main File
Subdivided
files and this
case there are
70 files