CCNA-RS-ITN-SIM-1 Configuring A Network Operating System Chapter 2 Exam
CCNA-RS-ITN-SIM-1 Configuring A Network Operating System Chapter 2 Exam
CCNA-RS-ITN-SIM-1 Configuring A Network Operating System Chapter 2 Exam
CHAPTER 2
CCNA-RS-ITN-SIM-1 Configuring a Network Operating System Chapter 2
Exam
Mandar
3 Oktober 2016
CCNA-RS-ITN-SIM-Ganjil-2016
MANDAR
3 OKTOBER 2016
KUNCI JAWABAN CHAPTER 2
MANDAR
3 OKTOBER 2016
KUNCI JAWABAN CHAPTER 2
10. A new network administrator has been asked to enter a banner message
on a Cisco device. What is the fastest way a network administrator could
test whether the banner is properly configured?
Exit privileged EXEC mode and press Enter.
11. Passwords can be used to restrict access to all or parts of the Cisco
IOS. Select the modes and interfaces that can be protected with passwords.
(Choose three.)
VTY interface
console interface
privileged EXEC mode
12. While trying to solve a network issue, a technician made multiple
changes to the current router configuration file. The changes did not
solve the problem and were not saved. What action can the technician take
to discard the changes and work with the file in NVRAM?
Issue the reload command without saving the running configuration.
13. Which statement is true about the running configuration file in a
Cisco IOS device?
It affects the operation of the device immediately when modified.
14. Which interface allows remote management of a Layer 2 switch?
the switch virtual interface
15. Why would a Layer 2 switch need an IP address?
to enable the switch to be managed remotely
16. What benefit does DHCP provide to a network?
Hosts can connect to the network and get an IP address without manual
configuration.
17. What command can be used on a Windows PC to see the IP configuration
of that computer?
ipconfig
18. What criterion must be followed in the design of an IPv4 addressing
scheme for end devices?
Each IP address must be unique within the local network.
19. Refer to the exhibit. A switch was configured as shown. A ping to the
default gateway was issued, but the ping was not successful. Other
switches in the same network can ping this gateway. What is a possible
reason for this?
The no shutdown command was not issued for VLAN 1.
MANDAR
3 OKTOBER 2016
KUNCI JAWABAN CHAPTER 2