FEG - Pa63 Pistol
FEG - Pa63 Pistol
FEG - Pa63 Pistol
PA-63
Double Action – Semi-Automatic Pistol
9x18mm Makarov
Even though you may be familiar or have had experience with other
firearms, each firearm is different. In order to understand the basics
of the PA-63, this manual should be read in its entirety. Enrollment in
an NRA-approved safety course is encouraged if you are unfamiliar
with firearms.
CAUTION
AMMUNITION SPECIFICATIONS
DISASSEBMLY
ASSEMBLY
With the safety “On” and the hammer cocked, pull the trigger guard
downward and to the side allowing it to rest on the frame. Holding the
trigger guard in this position, you can now replace the slide. Place the
end of the recoil spring in the slide and pull the slide back to the end
of its travel. Push it flat down on the frame allowing it to slide forward
to its normal position on the frame. Return the trigger guard to its
normal position.
OPERATION SAFETY
The safety lever is on the left side of the slide. It is “ON” when the
lever is turned down to cover the red dot; it is “OFF” when the lever is
turned up exposing the red dot. The safety lever locks the firing pin,
shields the firing pin, and uncocks the hammer. (If it’s already
uncocked, keeps it from being cocked.).
Note: When the safety is placed on “ON” and the hammer is cocked,
the hammer will drop forward, but cannot strike the firing pin. Keep
your finger off the trigger and the muzzle pointed in a safe direction.
To lower the hammer from the cocked position without letting it fall
down in the normal fashion, with the right hand thumb, hold back the
hammer and use the left hand to turn the safety lever “ON”. Now
ease the hammer down.
LOADING
3. With the safety on “ON” and your fingers away from the trigger,
chamber the first round. Place the full magazine into the pistol
until it is held by its catch. Hold the pistol with the right hand;
with the left hand, grasp the rear of the slide and pull the slide
fully to the rear and release. The slide will snap forward
chambering the first shell. Note: The hammer cannot be cocked
until the safety lever is turned “OFF” exposing the red dot.
UNLOADING
With the safety on “ON”, remove the magazine. Pull back on the slide
to eject any shells remaining in the chamber. Keep the slide held to
the rear and check to make sure that the pistol is empty.
A. TRIGGER D. HAMMER
B. BARREL E. SLIDE
C. CARTRIDGE IN CHAMBER F. FRAME
FIRING
To shoot double-action, point the pistol at your target, push the safety
“OFF” with your thumb, take aim and pull the trigger the full length of
its travel. This will cock and drop the hammer in one motion, firing
the pistol and recocking it for the next shot.
To shoot single-action, point the pistol at your target, push the safety
“OFF” and cock the hammer fully to the rear. Keep your finger off the
trigger while cocking the hammer! To shoot, pull the trigger. For each
succeeding shot, the hammer is automatically cocked at the single
position until the magazine is empty. The slid will remain fully to the
rear after the last shot.
If you wish to stop shooting after the first magazine is empty, turn the
safety “ON” and remove the empty magazine. Pull the slide to the
rear and allow it to run forward slowly uncocking the hammer.
PARTS LIST
Important. When ordering please give the model of the pistol for
which the part in question is required.
Always clean all the grease and oil from the chamber and the bore
before loading. Be sure there is no obstruction in the barrel. Any
foreign object in the barrel could cause a burst barrel or other damage
to the firearm as well as injury to the shooter or others.
Never fire any pistol with any part of your body over or next to the
ejection port, or any position where you could possibly be hit by the
movement of the slide.
Never allow others to stand beside you where they may be hit by an
ejected cartridge case. Make certain there is an unobstructed path for
safe ejection of the fired case.