NT600 Pi04066
NT600 Pi04066
NT600 Pi04066
NT 600
Modular Wiring Tester
■ Easy operation via PC with control software ■ The NT 600 is the ideal entry-level tester –
NT Control easy expandable for future test requirements
■ Comfortable test program editors ■ Low start-up costs
■ Extensive display possibilities and tools for fault location ■ Easy expandable*:
in the unit under test ▪ Additional measurement electronics
■ Extensive result reporting to file, to printer or via ▪ LCR measurement bridge
database connection* ▪ Test point expansion via test point units
■ Up to 1024 test points in the base unit, expandable via ▪ Four-wire measurement from 1 mOhm
additional units up to max. 5120 test points ▪ Insulation tests up to 10 GOhm
■ Continuity test, short circuit test and component test ■ Test table support
■ High current test up to 2 ADC* ■ The demands of the following test standards
■ High voltage test up to 1500 VDC* are complied with:
■ Dielectric strength test up to 1060 VAC / 1500 VDC* IPC/WHMA-A-620, MIL-STD-202G,
■ Remote maintenance NASA-STD 8739.4A, MIL-HDBK-83575,
MIL-STD-1344A, MIL-C-45224D
* optional
TESTING
NT 600
Options
Measurement electronics expansion
to the base equipment MT20 up to 25 VDC / max. 25 mA
■ Measurement electronics:
▪ MT40-40 up to 40 VDC / max. 100 mA
▪ MT40-250 up to 250 VDC / max. 10 mA
▪ MT1500DC up to 1500 VDC / max. 2 A
High voltage insulation test / high current continuity test
(optional up to 40 VDC / 10 A pulsed)
▪ MT2000 up to 1060 VAC / 1500 VDC
Dielectric strength test, max 3 mA or 6 mA
■ Internal AC measurement bridge MT_LCR for the test of
inductances, capacitances and resistances
■ Voltage measurement device MT_EXT for the voltage measurement
up to 700 VDC and 500 VAC (max. 400 Hz)
■ Four-wire (Kelvin) measurement for measuring low resistances from
1 mOhm
Function test
■ Stimulus cards
■ Stimulus sources
■ Test and programming of one-wire devices
■ Total integration of camera systems for visual tests
■ ProfiNet, LIN-, CAN-, Mod-Bus TCP, other bus systems on request
Additional services
■ Training for programming and testing with NT Control and NT 600
■ Calibration service
■ Application specific assistance
General
Interfaces Interface for expansion units
Extern interface with 3 opto-coupled inputs and 3 potential free outputs (expandable)
Serial interfaces RS232 / USB 2.0
Network
Pin number probe
Dimensions (W x H x D, approx.) Base unit: 450 mm x 275 mm x 395 mm
Test point unit 0ZE31: 450 mm x 150 mm x 395 mm
Scope of delivery base unit NT 600, main cable, pin number probe, USB flash drive with NT Control and documentation in
PDF format, mating connector and service connector for safety loop
* PC not in the scope of delivery
Technical changes reserved – copyright 2019 adaptronic Prüftechnik GmbH, DE-97877 Wertheim – PI-04-066-J
www.adaptronic.de Competence in Testing.