Cummins EA - T - CC - 19 - EN
Cummins EA - T - CC - 19 - EN
Cummins EA - T - CC - 19 - EN
Diesel
generator set
QSK60
series engine
1875-2250kVA 50 Hz
Data Center Continuous
Description
This Cummins commercial generator set is a fully Control system – The PowerCommand® electronic control
integrated power generation system, providing optimum is standard equipment and provides total genset system
performance, reliability, and versatility for stationary integration including automatic remote starting/stopping,
Standby, Prime power, and Continuous duty applications. precise frequency and voltage regulation, alarm and status
message display, AmpSentry™ protection, output
metering, auto-shutdown at fault detection and NFPA 110
Made by Cummins Level 1 compliance.
Data Center Continuous (DCC) - Applicable for supplying
power continuously to a constant or varying electrical load Cooling system - Standard integral set- mounted radiator
for unlimited hours in a data center application. system, designed and tested for rated ambient
temperatures, simplifies facility design requirements for
rejected heat.
Uptime Compliant - Meets the requirement of a Tier III
and IV data center site by being rated to run for unlimited NFPA - The genset accepts full rated load in a single step
hours of operation when loaded to 'N' demand for the in accordance with NFPA 110 for level 1 systems.
engine generator set.
Warranty and service - Backed by a comprehensive
warranty and worldwide distributor network.
Cummins heavy-duty engine - Rugged 4- cycle industrial
diesel delivers reliable power, low emissions and fast ISO8528-5 G3 Capable- Refer to factory for stie and
response to load changes. configuration specific transient performance
classification.
Permanent Magnet Generator (PMG) - Offers enhanced
motor starting and fault clearing short circuit capability.
Engine specifications
Design 4 cycle, 60° Vee, turbocharged and low temperature after-cooled
Bore 159 mm (6.25 in)
Stroke 190 mm (7.48 in)
Displacement 60.2 L (3673 in3)
Cylinder block Cast iron, 60ºV 16 cylinder
Battery capacity 2200CCA at ambient temperature 0ºF to 32ºF (-18 °C to 0°C)
Battery charging alternator 40 amps
Starting voltage 24- volt, negative ground
Fuel system Direct injection
Fuel filter Triple element Spin on fuel filters with water separator
Air cleaner type Dry replaceable element
Lube oil filter type(s) Four spin-on, combination full flow and bypass filters
Standard cooling system High ambient cooling system
Alternator specifications
Design Brushless, 4 pole, drip-proof revolving field
Rotor Direct coupled by flexible disc
Insulation system Class H
Standard temperature rise 125°C
Exciter type PMG (Permanent Magnet Generator)
Phase rotation A (U), B (V), C (W)
Alternator cooling Direct drive centrifugal blower fan
AC waveform total harmonic distortion No load < 1.5%. Non distorting balanced linear load < 5%
Telephone harmonic factor (THF) < 3%
Available voltages
50 Hz Line-Neutral/Line-Line
220/380 230/400 240/415 6060/10500
6350/11000
*Note: Consult factory for other voltage.
©2023 Cummins Inc. All rights reserved. Cummins is a registered trademark of Cummins Inc. PowerCommand, AmpSentry and InPower are trademarks of Cummins Inc. Other
company, product, or service names may be trademarks or service marks of others. Specifications are subject to change without notice.
EA_T_CC_19_EN (11/23)