Teto Abrir Mercedes Classe E w211
Teto Abrir Mercedes Classe E w211
Teto Abrir Mercedes Classe E w211
01
MODEL 211.0 /2, 240.0 with CODE (414) Glass electric tilting/sliding roof
1 Paneling
2 Covering
3 Front slide block
4 Rear slide block
5 Slide rail
6 Mounting wedge
P77.20-2268-06
Remove/Install
Danger! Risk of injury caused by fingers being When moving components, ensure that no AS00.00-Z-0011-01A
jammed or pinched when removing, body parts or limbs are within the operating
installing or aligning hoods, doors, trunk lid/ range of moving parts.
rear-end door or sliding roof.
1 Push paneling (1) toward rear See Operating Instructions
2 Open tilting/sliding roof approx. 20 cm See Operating Instructions
3 Unclip center and side covering (2) with *110589035900
mounting wedge (6), remove covering (2) from
rubber bellows*
Installation: Position covering (2) in center
and clip in.
4 Completely open tilting/sliding roof
5 Slide lining (1) forward
6 Unhook front slide block (3) from slide rail (5) * Press front slide block (3) back into mount
toward center of vehicle with suitable tool and
slide paneling (1) to opposite side to unhook.
7 Lift paneling (1) out of slide rail (5)
8 Pull cover (1) slightly forward over roof cutout Treat paneling carefully (1), otherwise
until rear slide blocks (4) are accessible* paneling (1) or paint can be damaged.
9 Unhook rear slide block (4) from slide rail (5). Press rear slide block (4) back into mount
toward center of vehicle with suitable tool and
slide paneling (1) to opposite side to unhook.
10 Lift paneling (1) out of slide rail (5) and remove
from vehicle
11 Install in the reverse order
110 589 03 59 00
Mounting wedge