MSDS TGR-243

MATERIAL SAFETY DATA SHEET (MSDS)
MSDS Number: TGR-243
1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION

Product name: TGR-243 Fin Coil Cleaner
Distributor: Tiger Rich Systems Company Limited.
Address: 55/9 Moo 5 Bangbuathong Bangbuathong Nonthaburi 11110
Tel: 02-9369017-8 Fax: 02-9369019
Application: Fin Cleaner
2. COMPOSITION/INFORMATION ON INGREDIENTS
Hazardous Ingredients: Sodium Metasilicate CAS NO: 6834-92-0 1-10 NE NE

Alkoxylated linear alcohol CAS NO: 68987-81-5 1-10 NE NE
Sodium dodecylbenzene Sulfonate CAS NO: 25155-30-0 1-
10 NE NE
DI Water CAS NO: 7732-18-5 NE NE to make 100
Nature of Hazard: None
3. HAZARDS IDENTIFICATION
Eye Contact: May cause irritant

Skin Contact: Irritant
Inhalation: Irritating to respiratory system
4. FIRST-AID MEASURES
General:
Inhalation: In case of overexposure remove to fresh air. Keep warm and at
rest. Seek medical attention immediately.
Ingestion: Do not induce vomiting. Give 200-300 ML of water to drink and
seek medical assistance immediately.
Eye Contact: Immediately flush eyes with water holding eyelids apart for at
least 10 minutes. seek medical assistance at once.
Skin Contact: Remove contaminated clothing. Wash skin thoroughly with water
and seek medical attention immediately.
5. FIRE-FIGHTING MEASURES
Extinguishing Media: Non flammable
6. ACCIDENTAL RELEASE MEASURES
Take the necessary precautions to prevent contact. Shut of leaks if this can be done
without personal risk. Contain the spillage if possible. Keep the area clear. Procedures for
Leaks or Spillages: Use absorbent sweeping compound to soak material, put into
container, Dispose as hazardous
7. HANDLING AND STORAGE

Handling: Wash hands after use
Storage: Keep away from acids, heat, sparkes, open flame and other
sources of ignition
Page 1 of 3
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Engineering Measures: Causes burns.

Respiratory Protection: Use in a well ventilated area, if high vapour/spray mists are
likely, fume extraction or breathing apparatus may be
required. Use only at ambient temperature to prevent mist
forming at freezing point which may be ingested.
Hand protection: Wear rubber gloves
Eye Protection : Safety glasses
Skin Protection: Long Sleeves and Long pants
9. PHYSICAL AND CHEMICAL PROPERTIES
Solubility in Water: Soluble

Physical State: Liquid
Appearance: Yellowish
Odour: Orange
PH: 11-12 Typical
Boiling Point/boiling range: 62 °C
Melting Point/melting range: N/A
Flash Point: N/A
Specific Gravity @ 20°C: 1.1
10. STABILITY AND REACTIVITY
Stability: Stable in normal use

Conditions to Avoid: Incompatible with strong oxidizing agents, alkalis, acids
11. TOXICOLOGICAL INFORMATION
Ingredient LD50 (Animal/Oral)

Eye Contact: Irritant
Skin Contact: Irritant
Inhalation: Irritating to respiratory system
Long Term: Ingredients are not known to be carcinogenic
12. ECOLOGICAL INFORMATION
There is no data available on the product itself.
13. DISPOSAL CONSIDERATIONS
as hazardous waste in accordance with EPA RCRA

14. TRANSPORT INFORMATION
Hazchem Code: None
ADR Class: N/A
IMDG: N/A
ICAQ/ATA: N/A
RID: N/A
Page 2 of 3
15. REGULATORY INFORMATION
Risk Phrases : 37 : Irritating to respiratory system

Safety Phrases : 36 : Wear suitable protective clothing, gloves and eye
protection
: 37 : Wear suitable protective clothing, gloves and eye
protection
: 39 : Wear suitable protective clothing, gloves and eye
protection
: 26 : In case of contact with eyes rinse immediately with plenty
of water and seek medical advice.
: 28 : After contact with skin wash immediately with plenty of
water. Store in a cool dry place and away from alkalis and
strong oxidizing agents.
: 2 : Keep out of reach of children
16. OTHER INFORMATION

The data and advice gives apply when the product is used for the stated application or
applications. The product is not sold as suitable for any other application. Use of the
product for applications other than as stated in this sheet may give rise to risks not
mentioned in this sheet. Approved Codes of Practice: Waste Management The Duty of
Care. Statutory Instruments: The Health and Safety at Work Act 1974
Environmental protection Act 1990. Control of Substances Hazardous to Health Regs
1988 Chemicals (hazard Information and Packaging) Regs. Guidance Publications:
Occupational Skin Diseases: Health and Safety Precautions (EH 2)
Occupational Exposure Limits (EH40)
**** END OF MSDS****
Page 3 of 3

MSDS TGR-243

Uploaded by

Copyright:

Available Formats

MSDS TGR-243

Uploaded by

Document Information

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

MSDS TGR-243

Uploaded by

Copyright:

Available Formats

MATERIAL SAFETY DATA SHEET (MSDS)

MSDS Number: TGR-243

1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION

Hazardous Ingredients: Sodium Metasilicate CAS NO: 6834-92-0 1-10 NE NE

Eye Contact: May cause irritant

Extinguishing Media: Non flammable

6. ACCIDENTAL RELEASE MEASURES

7. HANDLING AND STORAGE

8. EXPOSURE CONTROLS/PERSONAL PROTECTION

Engineering Measures: Causes burns.

9. PHYSICAL AND CHEMICAL PROPERTIES

Solubility in Water: Soluble

10. STABILITY AND REACTIVITY

Stability: Stable in normal use

11. TOXICOLOGICAL INFORMATION

Ingredient LD50 (Animal/Oral)

12. ECOLOGICAL INFORMATION

There is no data available on the product itself.

13. DISPOSAL CONSIDERATIONS

as hazardous waste in accordance with EPA RCRA

15. REGULATORY INFORMATION

Risk Phrases : 37 : Irritating to respiratory system

16. OTHER INFORMATION

**** END OF MSDS****

You might also like

END OF MSDS