C2 -cHcMa}4P0- parse Ler
swrscm
REPAIR : SEAT TRIM (LEATHER)
ESSENTIAL : Observe the safety and cleanliness recommendations @
‘CAUTION : Follow the user irstuetons inthe sea tim repa kit
1. Tooling
Equipment : Seat rim repair it
2. Preparing the zone to be repait
Fine CEMTERD
‘ean the zone tobe repaired using the degreaser provided inthe repair ki
Uniformly spread the product provided in the repair kit; Using tne adhesive kre
‘Allow to dy for 20 minutes or accoerate the drying using a heat source,
“Take away the moulding (1),
apt baat cSOMONOPOL CSCO De DF eFCTIOEswrscm C2 -cHcMa}4P0- parse Ler
Degrease using the degroaser included in the repair kt
Allow o dey
“Trim the edges ofthe hola; Using scissors.
Use the tweezers to separate the leather from the foam,
Cut the piece of backing fabric (2) into @ rounded overlapping shape,
Fae SMSO
Make a mark in the centre of the piece of backing fabric (2) (at "a",
apt baat cSOMONOPOL CSCO De DF eFCTIOEswrscm C2 -cHcMa}4P0- parse Ler
NB. : Make eure thal the mark on the backing fabric i al the centre af the hole (Make sure thal the fabric is extended fat underneath the lather
Put the place of backing fabric 2) n place Using either the twoezors or the adhesive knife
3. Applying the liquid leather
Fine CSOD
‘Apply the kquis leather (3) between the leather andthe backing fabric.
Fine oswFCD
Pre-heat the iron to positon 25.
Use the tefon shest provided, to go between the leather and the iron
apt baer cSCMOIOPOL CSCO De DF eFCTIOswrscm Cz -cscMa}40- parse Later
Use the heat to make the quid leather stick tothe backing fabri.
NB. : Repeat the operation of applying liquid leather to make it fush with the hol.
Remove any excess af liquid leather on the outer surface.
Fine CSERTFD
“Take the moulding (1) and pace It over the hole filed withthe tiqus eather.
NB, : Press gently so that it sticks,
‘Apply heat tothe area with the iron on positon 25.
“Take away the moulding (1),
4. Preparation / Application / paint
‘Apply the epair mast for a better fnish (using fresh arto dry it) (see operating instructions).
Carefully smooth with an abrasive pad to spread the porosity
‘Apply a thin coating of primer (see operating instructions),
Leave to dry for 10 minutes (approx).
apt baat cSOMONOPOL CSCO De DF eFCTIOEswrscm C2 -cHcMa}4P0- parse Ler
‘Apply the corresponding paint to the repaired zone (see operating instruction).
Leave to dry for 10 minutes (approx).
Fine CMO
NB. : Repeal the fllowing in wo slages.
‘Apply the fsshing gel (soe operating instuctons).
‘After the last application leave to dy for 30 minutes.
apt baat cSOMONOPOL CSCO De DF eFCTIOE