Nothing Special   »   [go: up one dir, main page]

NTB02 088

Download as pdf or txt
Download as pdf or txt
You are on page 1of 3

Classification: Reference: Date:

BT02-027 NTB02-088 September 1, 2002

SUNROOF OPENS AND/OR TILTS UP BY ITSELF

APPLIED VEHICLE: 2002-03 Maxima (A33)


APPLIED VINS: Vehicles built before JN1DA31A33T417593 (with SRS side air bags)

Vehicles built before JN1DA31D23T512639 (without SRS side air bags)

SERVICE INFORMATION
If an applied vehicle has the symptoms listed below:
• Sunroof opens by itself
AND/OR
• Sunroof tilts up by itself
use the following Service Procedure to resolve the incident.

SERVICE PROCEDURE
1. Try to confirm the incident does occur.
2. Make sure the sunroof is in the fully closed position.
3. Replace the sunroof slide switch with the one listed in the Parts Information table as
follows:
A. Remove two screws from the roof center console (which houses the sunglass
holder, map lights/switches, and sunroof controls). See Figure 1.

Sunroof
Front slide switch

Sunglass holder
(Fold down)
Screws (Remove) TP020367
Figure 1

1/3
B. Disconnect the map light and sunroof switch harness connectors from the vehicle
harness connectors (see Figure 2).
NOTE: For information about disconnecting the connectors, refer to the HARNESS
CONNECTOR description in the “EL” section of the applicable Service Manual.
Sunroof slide
switch harness
connector
Map light
harness
connector

Sunroof
slide switch

Screws (Remove)
TP020368
Figure 2
C. Remove two screws and remove the sunroof slide switch (see Figure 2).
D. Install the new sunroof slide switch and connect its harness connector to the vehicle
harness.
E. Re-connect the map light harness connector to the vehicle harness.
F. Re-install the roof center console and the two screws.
4. Make sure the sunroof operates normally with the new switch installed.

NOTE: If the sunroof does not operate normally, re-set the sunroof memory as follows:
• If the sunroof is open, press the tilting switch repeatedly toward tilt “Down” to fully
close the sunroof (see Figure 3).
• After the sunroof has closed all the way, keep pressing the tilting switch toward tilt
“Down” for more than three seconds.
Open/close Tilting switch
switch

Tilt
"Down"

TP020306
Figure 3

2/3
PARTS INFORMATION
DESCRIPTION PART NUMBER QUANTITY
Switch Assembly--Sunroof 25450-5Y710 1

CLAIMS INFORMATION
Submit a Primary Failed Part (PP) line claim using the following claims coding:

DESCRIPTION PFP OP CODE SYM DIA FRT


RPL Sunroof Slide Switch 25450-5Y710 UQ34AA FC 32 (1)
1. Reference the current Nissan Warranty Flat Rate Manual and use the indicated FRT.

3/3

You might also like