Final Project Review
Final Project Review
Final Project Review
R.HARIKRISHNA
DEPARTMENT OF ELECTRONICS & COMMUNICATION ENGINEERING VIGNAN INSTITUTE OF TECHNOLOGY AND SCIENCE DESHMUKHI
INTRODUCTION:
The main aim of this project is to provide hazard free vacuum path for blind people through obstacle sensing using microcontroller and sensor .Since sometimes blind people collide against high and moving obstacles, we need obstacles, we need obstacle-sensing function in front of the blind people .this paper proposes a method obstacles of point to point distance measurement using ultrasonic for excellence stick in order to detect moving and high
BLOCK DIAGRAM:
VIBRATION MOTORS
CRSTAL OSCILLATOR
A T 8 9 S 5 2
POWER SUPPLY
IR TX
555 TIMER
IR TX
BUZZER
POWER SUPPLY:
DC BATERRY 9V
VOLTAGE REGULATOR
5V OUTPUT
CURRENT STATUS:
Studied about my project and collected all the requirements needed for it . Designed the power supply circuit to obtain 5 Volts output.. Corrected the errors which occurred after designing it. Partially studied about the AT80s52 microprocessor.
Till here I have completed my project with the help of my guide, and still some part of microprocessor and studying about the voice IC ,program code ,interfacing is left. Which i will complete it as soon as possible.
256 x 8-bit Internal RAM 32 Programmable I/O Lines Three 16-bit Timer/Counters Eight Interrupt Sources Full Duplex UART Serial Channel Low-power Idle and Power-down Modes Interrupt Recovery from Power-down Mode Watchdog Timer Dual Data Pointer Power-off Flag Fast Programming Time Flexible ISP Programming (Byte and Page Mode) Green (Pb/Halide-free) Packaging Option
PIN CONFIGURATION:
Conclusion:
Till here I have completed my project and still around 40 to 45% is left .so I will b completing it before my third review.