Tk418 Lte Cat m1 Nb1 Iot Tracker Manual en
Tk418 Lte Cat m1 Nb1 Iot Tracker Manual en
Tk418 Lte Cat m1 Nb1 Iot Tracker Manual en
For Vehicle
<GNSS+GPRS+LTE CAT M1/NB1+SOS/Temperature+Battery>
TK418
User Manual
- Real-Time Vehicle Tracking System - -
1
CATLOG
Ⅰ. Product Features.............................5
Ⅱ. Components and Accessories.....7
Ⅲ. SIM card Installation.....................9
Ⅳ. Device Installation...................... 10
4.1 Install device......................... 10
4.2 Device wiring definition....... 12
4.3 Relay wiring..........................14
Ⅴ. Power On / Off............................. 15
5.1 Power on............................... 15
5.2 LED Indicators......................15
5.3 Power off...............................16
Ⅵ. Inquiry/Monitoring/Cut Oil......... 16
6.1 Inquiry by service platform.. 16
6.2 Inquiry by SMS.....................17
6.3 Cut Oil /Restore.................... 17
Ⅶ. device Alarm............................... 17
7.1 Temperature Alarm............... 17
2
7.2 Vibration Alarm.................... 18
7.3 Collision / falling Alarm....... 18
7.4 Speed Alarm..........................18
7.5 Shift Alarm............................19
7.6 Geo-fence Alarm...................19
7.7 Power disconnect Alarm....... 19
7.8 Low battery Alarm................ 19
Ⅷ. Device Setting........................... 20
Ⅸ. Trouble shooting.........................20
9.1 Cannot connect platform.......20
9.2 Offline status......................... 21
9.3 No positioned........................ 21
9.4 Position drift..........................22
9.5 Commands receiving
abnormally.................................. 22
Ⅹ. Warranty Rules............................ 22
10.1 Special statement................ 22
10.2 Warranty period...................23
10.3 After sales............................23
3
Welcome to use our device,please read this
manual carefully to install and operate device
exactly. This user manual is for reference only.
If some contents and operation steps are
inconsistent with those for the actual product,
the latter will prevail.
4
Ⅰ. Product Features
5
Basic Specifications
Voltage 12/ 24/ 36/ 48/ 60/ 72 VDC
Work Current GPRS(245-265mA); LTE(260mA)
6
Ⅱ. Components and Accessories
■ Components
-Top Front-
(Towards sky)
-Bottom -
7
■ Accessories
Temperature Sensor(Optional)
8
Ⅲ. SIM Card Installation
Open the packing case, check if device is OK
and accessories are intact,
9
Press cover and close
Note:
Ⅳ. Device Installation
11
4.2 device wiring definition
4.3.2 Cut off the positive pole of the fuel pump, next
serial connect the positive pole to the 87a port of
the relay, and connect another pole to 30 port,
showing as in the figure.
14
Bottom of the relay Wiring Diagram
Ⅴ. Power On / Off
5.1 Power on
Power on: insert a valid SIM card and wire all the
cables, device will power on.
15
1. Red LED(indicates GSM/LTE working state)
Searching for
Fast blinking
GSM/LTE network
GSM/LTE works
Slow blinking
normally
2. Blue LED(indicates GPS signal state)
Searching GPS
Fast blinking
Satellites
Slow blinking GPS works normally
Ⅵ. Inquiry/Monitoring/Cut Oil
6.1 Inquiry by service platform
6.1.1 Web Browser platform
Login the service platform and enter your ID and
password to check the position of device. Please
ask your dealer for the WWW address of the
position service platform.
6.2.2 Smart phone applications
You can use a smart phone to check device’s
position. We have prepare for you the Android client
16
(Android), Apple clients (IOS), please check with
your dealer to get installation package.
6.2 Inquiry by SMS
You can write a positioning SMS sending to device
to inquiry position, device will reply position SMS or
map link. The SMS commands please refer to the
Operation Commands
6.3 Cut Engine/Restore
6.3.1 Cut off oil circuits
Server(GPRS/LTE) or Manager number (SMS) can
send cut-fuel-circuit commands to device when
needed. Engine can not start, vehicle will be locked.
To make sure safety of vehicle, fuel of vehicle Can
be cut off only if device has been positioned by
GPS and speed of vehicle is less than 20KM/h or
vehicle is static.
6.3.2 Recover oil circuits
Server(GPRS/LTE) or Manager number (SMS) can
send recover-fuel-circuit commands to device when
needed, device will recover fuel circuits of vehicle.
Ⅶ. Device Alarm
7.1 Temperature Alarm
Conditions: When Temperature exceed set range
Note: You need to set Temperature range value &
17
time.
Or SOS Alarm
Conditions: When SOS button is long pressed for 3
seconds.
Note: SOS button must be installed (optional
accessory), and SOS administrator number must be
set. When the SOS alarm occurs, terminal will dial
the set SOS administrator number 3 times until get
through.
Note: When above alarm occurs, Device will send
alarm to service platform, meanwhile send a SMS
message to administrator number if this number
was set.
7.2 Vibration Alarm
Conditions: When the Vehicle Vibration occurs.
Note: You need to set vibration sensitivity and time,
there is an alarm switch.
7.3 Collision / falling Alarm
Conditions: When Vehicle Collision or falling
occurs.
7.4 Speed Alarm/Cut engine when
over speed
Alarm Conditions: When vehicle speed over and
below the setting speed.
Cut engine Conditions: Cut engine when over
18
setting speed (Restore engine after returning
setting speed)
Note: You need to set the low speed limit and the
high speed, and an over-speed setting to cut engine
7.5 Shift Alarm
Conditions: When vehicle occur a setting shift in the
Flameout status.
Note: Only valid in flameout state and vehicle occur
a setting shift distance.
7.6 Geo-fence Alarm
Conditions: when the vehicle entry / exit / across
the Geo-fence.
Note: You need to set the conditions of crossing
fence, fence types and so on.
7.7 Power Disconnect Alarm
Conditions: When the device is disconnected from
external Power.
7.8 Low Battery Alarm
Conditions: When the device is disconnected from
external Power and built-in battery power falls
below a certain value .
19
Note: When above alarm occurs, device will send
alarm to service platform, meanwhile send a SMS
message to the administrator number if the number
is set.
Ⅷ. Device Setting
Please refer to <Operation Commands>
Ⅸ. Trouble shooting
20
9.2 Offline status
First check if LED indicators are OK, if cannot
check them, you can check SIM card following next
steps:
1)call SIM card of device and check if you can hear
connecting ring.
2)Check if vehicle is in the area where there is no
GSM/LTE signal.
3)Check if one device or all devices are offline in
the area . If all devices are offline, you should ask
operator If network is OK.
4)Check if SIM card has enough balance.
5)If device becomes offline on the last day of one
month, please check GPRS is closed or not.
6)Inquiry parameters of device via commands and
check replied parameters.
9.3 No positioned
If the GPS is active, but device cannot be
positioned for long time, please check device:
21
face toward the sky.
3)The GSM/LTE and GPS signal may be
weakened if device is installed in the place with
electromagnetic wave absorption material(such as
metal blocks), special attention should be paid if
there is metal thermal insulation layer or heating
layer on the front windshield, so that the position
accuracy will decline, and the severe ones will not
be positioned.
Ⅹ. Warranty Rules
22
2) If the color and appearance are inconsistent with
those for the actual product, the latter will prevail.
3)Warranty card is only valid for devices with the
following IMEI.
4)Please take care of the warranty card and show
it with the original purchase receipts when enjoying
the warranty service.
23