Nothing Special   »   [go: up one dir, main page]

New Agilis-ALB-129-series-80w-ku-buc-Ku-Band-Block-Up-Converter-Spec-Sheet

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

Agilis_Product Sheet_ALB229 Series 80W-100W Ku BUC.

pdf 1 3/5/13 5:43 PM

ALB129 Series
Compact 80W
C Ku Band Block Up Converter
M

Y
This small and lightweight BUC is ideal for mobile and Quality Assurance
CM satellite uplink applications.
100% of all BUCs go through stringent quality checks
MY The BUC has “Best in Class” efficiency and “lowest in addition to well defined Electrical Stress Screening
CY
power consumption.” The unit works on a wide range to ensure operation in harsh outdoor environments.
AC power supply of 96VAC to 264VAC. Innovative The BUCs are also subjected to seal test for water
CMY
and efficient thermal design makes this BUC one of ingress verification.
K the smallest, robust, reliable and rugged enough to
withstand outdoor conditions in the industry. Reliability
Built-in redundancy feature eliminates the use of an Field proven under harsh environment conditions,
external controller for 1:1 redundancy operation. This Agilis ODUs can withstand temperature ranging from
eliminates messy cabling at the antenna making this a -40ºC to +60ºC with up to 100% humidity.
very elegant solution.
Extensive M/C interface with RS232/RS485/Ethernet
(SNMP & HTTP).

Features
• Compact and lightweight
• Available in standard and extended Ku-Band
• Forward power detection
• Intuitive monitoring & control through RS232/RS485
& Ethernet (SNMP & HTTP),
• Automatic fault identification & alarm generation
• Temperature compensation facility
• Built-in redundancy facility
• Built-in 10MHz reference with auto-detection
• Wide operating temperature range -40ºC to +60ºC
• RoHS Compliant
• Waterproof
Agilis_Product Sheet_ALB229 Series 80W-100W Ku BUC.pdf 2 3/5/13 5:43 PM

ALB129 Series
Compact 80W
Ku Band Block Up Converter

Technical Specifications
RF Specifications Monitor And Control
Transmit Frequency 14.00GHz – 14.5GHz (Std Ku) Monitor BUC temperature
13.75GHz – 14.5GHz (Ext Ku) Status alarm
IF Frequency Range 950MHz – 1450MHz (Std Ku) Output power
LED status indication
950MHz – 1700MHz (Ext Ku)
LO Frequency 13.05GHz (Std Ku)
12.80GHz (Ext Ku)
Output Power 49dBm (P1dB) Control Attenuation
RF output mute
Spectral Re-growth -30dBc @ Single carrier 3dB back-off from
P1dB at 1.0 x symbol rate offset for OQPSK or Interface RS232/RS485 & Ethernet (SNMP & HTTP) /
Third Order Intermod (two tone) QPSK -25dBc @ two carrier 2MHz apart at 3dB WIFI (Optional)
back-off from P1dB
Small Signal Gain 75dB Min Tx Redundancy Built-in
Gain Flatness Full Band ±2dB
Gain Slope over 40MHz ±1dB Environmental
Gain Variation over ±2dB @ from -40ºC to +60ºC
temperature Gain Control 20dB in step of 0.5dB Operating Temperature -40ºC to +60ºC
C O/P spurious According to EN301428
Phase Noise @ Offset Humidity Up to 100%
Weather protection sealed to IP65
M
1KHz -73dBc/Hz
10KHz -83dBc/Hz
Mechanical
Y

100KHz -93dBc/Hz
CM
I/P VSWR 1.5:1 Size 370L x 200W x 150H mm
MY O/P VSWR 1.25:1 with external Isolator
Noise Power Density Tx BD -70dBW/4KHz
CY
Rx BD -142dBW/4KHz Weight 9.5kg
CMY

K
Color White Powder Coat
Power Requirement
Note: All specifications are subject to change without notice.
Prime Power 230VAC (range 96V to 264VAC) Rev. 270615

Power Consumption 550VA Typical at P1dB

Interfaces
IF Input Interface 50Ohms N-type Female
Output Interface WR 75G

External Reference
Frequency 10MHz
Power -5dBm to +5dBm
Internal reference Built-in
External reference phase noise
Requirement @ frequency offset
1KHz -150dBc/Hz
10KHz -155dBc/Hz
100KHz -160dBc/Hz

VT iDirect, Inc. • 13861 Sunrise Valley Drive, Herndon, VA 20171 • Tel: +1 703.648.8000 +1 866.345.0983 • www.idirect.net

You might also like