MasterRoc FLC 100 Formerly Known As Meyco Flowcable TDS
MasterRoc FLC 100 Formerly Known As Meyco Flowcable TDS
MasterRoc FLC 100 Formerly Known As Meyco Flowcable TDS
DESCRIPTION OF PRODUCT the grout to both the steel anchor and the
surrounding rock/soil.
MasterRoc® FLC 100 contains a very efficient
water reducing agent, a shrinkage compensating
component and thixotropic agents. It is added
to cement at a rate of 3 - 6% by weight of cement
to make a pumpable, thixotropic grout with a
low water/cement ratio.
Due to the strong water reduction effect a w/c
ratio of approximately 0.25 can be used. This
allows the grout to achieve very high early and
final strengths. MasterRoc® FLC 100 has a very
long working time to enable complete filling of The slight expansion of MasterRoc® FLC 100 grout
the anchor hole or duct. ensures full bonding of steel anchors and rock bolts.
1. Always use a stiff PVC tube to pump the grout. MasterRoc® FLC 100 is highly alkaline when wet.
A small piston or worm pump should be used. Avoid contact with the skin and eyes. Wash skin with
2. Flush anchor holes with air or water before soap and water on contact with the product. Should
installation of the anchors. eye contact occur flush with plenty of clean water and
seek medical advice.
Pre-grouted Anchors During handling wear eye protection and a dust mask.
The use of suitable gloves and/or a barrier cream is
1. Place the PVC hose in the bottom of the drill recommended.
hole and start pumping.
2. Withdraw the pipe slowly. To ensure complete DISCLAIMER
filling of the hole some surplus grout should be
allowed to flow out of the hole when the anchor The technical information given in this publication is
is installed. based on the present state of our best scientific and
3. Install the anchor and lock it into position so practical knowledge. BASF Türk Kimya Sanayi ve
that it cannot move. Tic. Ltd. Şti. is only responsible for the quality of the
product. BASF Türk Kimya Sanayi ve Tic. Ltd. Şti.
Pre-grouted Anchors, Tube Anchors is not responsible for results that may occur because
the product is used other than advised and/or out of
1. Connect the hose to the anchor and start instructions regarding the place and the method of
pumping. use. This technical form is valid only till a new version
2. Continue until the grout is squeezed out is implemented and nullifies the old ones.
between the disc and the rock. When grouting
tube anchors, it may be necessary to make the Contact Information
grout more fluid. However, ensure that the grout
is pumped into the hole and does not flow into BASF Türk Kimya San. ve Tic. Ltd. Şti.
it or there may be a risk of incomplete filling. Yapı Kimyasalları Bölümü
Tel: 0216 570 34 00
PACKAGING Fax: 0216 570 37 79
Mail: info@master-builders-solutions-turkey.com
MasterRoc® FLC 100 is available in 10 kg bags. www.master-builders-solutions.basf.com.tr