2.7.6 Packet Tracer - Implement Basic Connectivity
2.7.6 Packet Tracer - Implement Basic Connectivity
2.7.6 Packet Tracer - Implement Basic Connectivity
Objectives
Part 1: Perform a Basic Configuration on S1 and S2
Part 2: Configure the PCs
Part 3: Configure the Switch Management Interface
Background
In this activity, you will first create a basic switch configuration. Then, you will implement basic connectivity by
configuring IP addressing on switches and PCs. When the IP addressing configuration is complete, you will
use various show commands to verify the configuration and use the ping command to verify basic
connectivity between devices.
Instructions
Part 1: Perform a Basic Configuration on S1 and S2
Complete the following steps on S1 and S2.
Step 2: Configure the console and encrypted privileged EXEC mode passwords.
a. Use cisco for the console password.
b. Use class for the privileged EXEC mode password.
How can you verify that both passwords were configured correctly?
After you exit user EXEC mode, the switch will prompt you for a password to access the console interface and
will prompt you a second time when accessing the privileged EXEC mode
Type your answers here.
© 2013 - 2021 Cisco and/or its affiliates. All rights reserved. Cisco Public Page 1 of 3 www.netacad.com
Packet Tracer - Implement Basic Connectivity
© 2013 - 2021 Cisco and/or its affiliates. All rights reserved. Cisco Public Page 2 of 3 www.netacad.com
Packet Tracer - Implement Basic Connectivity
© 2013 - 2021 Cisco and/or its affiliates. All rights reserved. Cisco Public Page 3 of 3 www.netacad.com