Transmission Diagnostic Trouble Codes F343-F348
Transmission Diagnostic Trouble Codes F343-F348
Transmission Diagnostic Trouble Codes F343-F348
F345 S6 Park/Not Neutral Eight Way connector Neutral Verify that the gear selector switch is wired as shown
On Gear Position Switch on Shift handle wired Only in the wiring diagram. See Transmission Controller
Occurrence Module. wrong; Circuit in 9015-10. System Functional Schematic.
Request for an
undefined shift being
made.
(A) W21 WHT/TCU
J2-B1
(B) Wire W17
WHT/TCU J2-A2
(C) Wire W18
WHT/TCU J2-A3
(D) Wire W19
WHT/TCU J2-H3
(E) Wire W20
WHT/TCU J2-H2
file:///C:/ProgramData/Service%20ADVISOR/Temp/tm1606_TXTX17864920471536.html 03/08/2021
Page 2 of 2
F348 Transmission Output Transmission Output Fuse Neutral Replace Transmission Output Fuse
On Power Low is open; Valve Driver Reset in
Occurrence NOTE: This can occur Supply Voltage (J3-A1) neutral
during power off of Too Low.
machine on vehicles with
(SN -567462).
P11 RED Wire open or Disconnect the TCU and measure the
shorted to ground. Pin J3- voltage on the TCU connector. If no voltage
A1 at TCU. check for continuity to GND. Examine
Harness for a wire open or shorted to GND.
CED,TX17864,1056-19-19990303
file:///C:/ProgramData/Service%20ADVISOR/Temp/tm1606_TXTX17864920471536.html 03/08/2021