Merlin Keypad Manual
Merlin Keypad Manual
Merlin Keypad Manual
USER MANUAL
SINGLE ZONE
1
MERLIN Electric Fence Control Panel User Manual
To switch the fence On or Off, enter your four digit PIN followed by the # key. The control panel will
beep twice to confirm that the fence is off and three times when the fence is turned on.
• Don’t pause for more than 5 seconds while entering the digits, or the control panel will reject
your PIN number
• If you make a mistake while entering your PIN, press the # key and start again
Enter your PIN and push the # key. This will silence the buzzer and siren. It will not switch the fence
off. One of the ALARM lights will flash or stay lit to indicate the type of alarm. Investigate the cause of
the alarm and correct it. After the ALARM light stops flashing, enter your PIN and push the # key to
clear the alarm memory.
Enter your PIN and push the * key, enter the digit ‘3’, then push# key. The control panel will beep three
times to confirm the fence is in low voltage mode. When the fence is on and in low voltage mode, the
red ON light will flash. The red ON light will stay lit if the fence is in high voltage mode.
Enter your PIN and push the * key, enter the digit ‘1’, then push the # key. The control panel will beep 3
times and the FENCE ALARM light will start flashing slowly to confirm the fence alarm is bypassed. To
cancel the bypass, repeat the same sequence of keys.
Enter your PIN and push the * key, enter the digit ‘4’, then push the # key. The control panel will beep 3
times to confirm the siren and strobe light is bypassed. The beeper in the control panel and the
energizer unit will still be active.
Enter you PIN and push the * key, enter the digit ‘7’, then push the # key. The control panel will beep
twice to confirm that the siren and strobe light is NOT bypassed.
2
MERLIN Electric Fence Control Panel User Manual
Enter you PIN and push the * key, enter the digit ‘2’ followed by the digit ‘7’, then push the # key. The
control panel will beep twice and the GATE ALARM light will start flashing very slowly (every 5 seconds)
to confirm that the gate alarm is immediate.
Enter you PIN and push the * key, enter the digit ‘2’ followed by the digit ‘4’, then push the # key. The
control panel will beep twice to confirm that the gate alarm is delayed. The default delay time is 4
minutes.
Enter you PIN and push the * key, enter the digit ‘2’, then push the # key. The control panel will beep 3
times and the GATE ALARM light will start flashing slowly to confirm the gate alarm is bypassed. To
cancel the bypass, repeat the same sequence of keys.
Push the * key, enter the digit ‘2’, then push the # key. The control panel will beep twice to confirm that
the gate chime is turned off and three times if it’s turned on. If the chime is on, the control panel will
beep twice if the gate closes and three times if it opens.
Enter you PIN and push the * key, enter the digit ‘9’, then push the # key. The control panel will beep 3
times and the SERVICE ALARM light will start flashing slowly to confirm that the service alarm is
bypassed. To cancel the bypass, repeat the same sequence of keys.
Push the * key, enter the digit ‘6’, then push the # key. The control panel will beep twice and start
testing the battery. The default battery test duration is 5 minutes.
KEY DEFINITIONS:
RANDBURG EDENVALE
Tel: +27 (0)11 462-8283 Tel: +27 (0)11 453-1970
Fax: +27 (0)11 462-7132 Fax: +27 (0)11 453-1858